ft 817 mounting bracket 3d models
437640 3d models found related to ft 817 mounting bracket.
thingiverse
This is an updated version of tandro's fantastic battery holder. I made some key changes to accommodate a different fuse holder and add deeper wire channels between the positive and negative battery terminals that get connected for added flexibility....
thingiverse
To improve the original knob's hard rubber surface, a crank knob and Oogoo mold were created for a softer rubber sleeve. The STL of the rubber sleeve is available for those who want to print it with flexible filament. The sleeve diameter is 1 mm...
thingiverse
Stand a metal rod with a hexagonal head, called an M4 screw, and a matching nut in place of your feet inside the safety enclosure made by a three-dimensional printer. ...I need two instances of this combination.
cults3d
I didn't really like the rather hard rubber surface of the original knob and wanted a crank anyway, so I made a crank knob and a fitting Oogoo mold to make a softer rubber sleeve for it. I also included an STL of the rubber sleeve if you want to try...
thingiverse
The bracket attaches to the screws holding together the FT-5 X carriage's two components, making it incredibly simple to add or remove as needed. You can slide it forward or backward along the screws to achieve precise alignment. Modifying the spacer...
thingiverse
Mounting the Y-pcb board to the FT-6 requires careful attention to detail. Begin by ensuring all components are properly aligned and securely fastened to prevent damage or malfunction during the assembly process. Next, carefully insert the Y-pcb...
thingiverse
There are some new Y-Motor Mount brackets to go with these idlers. Update 23 Feb 2019: Adjusted the spacing on the holes by 1mm (from 49mm to 50mm). This allows for an exact 30mm between the rails. Increased thickness to 6.5mm to allow for a tight...
thingiverse
... This adapter is intended for the FT-6, but it should fit any cyclops clone with the same geometry as the 2 in 1 out extruder (https://www.aliexpress.com/item/32796885685.html). The branded cooling block with 'NF' marked on it could also work.
thingiverse
A customized connector for the RJ45 breakout board is designed to be mounted on the rear of the X carriage support structure.
thingiverse
... radios with a M4x50 mounting pattern. Has adjustable tilt built in and uses M4x14 screws. I put a piece of rubber underneath and it is heavy enough to stay put on my desk, but if there's interest I can put some mounting holes in the base as well.
thingiverse
Mounting the Yaesu FT-7900R to a Jetstream JTPS31MA power supply for portable operations requires careful bracket installation. ...Securely fasten the brackets to the radio and power supply using M4x8 screws, ensuring a sturdy and reliable connection...
thingiverse
Simple replacement for ridge mounted whiteboard bracket. ...
thingiverse
Mounting bracket for the SpringCard FunkyGate readers.