geckodrive 3d models

40mm fan holder for Geckodrive G540 Onshape link : https://cad.onshape.com/documents/20fa2533ce8bcf08fdec0e70/w/eae39ef00925afcbec05d8e9/e/831454e68afb2cc680d013a4

I needed some cooling for my Geckodrive G540, so I threw this together in Fusion 360 (I'm still learning how to use Fusion). Uses 60mm fans. ...Use standoffs as the "nuts" when you mount the G540, then screw the fan bracket to the standoffs.

A basic bracket for mounting a Geckodrive G540 onto 2020 extrusion railing.

The famous Gecko 203V stepper drive. I drew all the sketches off of the lineart (so they're still in there) from Gecko along with some rough measurements of the physical part. The mounting hole patters are correct, which is all that reallymatters.

This is the GeckoDrive G540 CNC Stepper Controller. I just CADed it up for designing my electronics enclosure for my CNC. ...Its 95% accurate, some of the non-critical details were omitted because I was strictly going off the manuals and images on the...

Here's a CAD model of the G251X module with all of the dimensional data pulled from the datasheet they provide along with am actual unit I have to measure off of. ...Have fun...

I was shocked to find that nobody had modeled the G540 driver from Gecko. I needed it for a project so I modeled it up using the Gecko Users manual dimensions along with some measurements from my G540. It is in STEP format. ...With and Without Cables to...

This is an enclosure for the g540 stepper motor controller from geckodrive.com. Some of the holes may require boring after print. The standoffs line up well for a 48v psu. You can use netfabb basic (free version) to cut the models to a size that...

I made this to mount the Geckodrive G540 Stepper Motor Driver in my control box. I decided to change the design and put a 0.500" clearance between the bottom of the controller to help with cooling since i am going to pt a fan blowing on it. ...Screws...

Geckodrive are legendary among the CNC community, and their stepper drives are considered by many to be the gold standard. Made in the USA, Geckodrive motor controls offer mid-band resonance compensation, high speed step morphing, and tunable low...

With the 1.8Nm stepper motors I use with geckodrive g540 it achieves up to 5m/min rapids and 3m/min feedrates. The working area is about 110cm x 60cm x 10cm. Expected cost to build a machine like this from scratch is 1000-1300 euros. It also took...

I made this to mount the Geckodrive G540 Stepper Motor Driver in my control box. ...I decided to change the design and put a 0.500" clearance between the bottom of the controller to help with cooling since i am going to pt a fan blowing on it.</p>...