gt2 belt 3d models

Freecad parametric GT2 Belt

I helped my friends create this gt2 belt for their project, it came out nice. The material used was ninjaflex, although it's a little stretchy it still has some rigidity. ...The inner diameter is 10cm.

simple gt2 belt clip

GT2 belt holder size 33X20X20mm

Nice belt tensioner for GT2 belt

belt clip for 10mm gt2 belts

X parallizer GT2 belt 1 x M3x10

GT2 aluminum belt clamp

Just my design of a gt2 belt lock.

Tensioner for GT2 Belt! ... Use M4 Screws and Nuts

GT2 belt pulley for printer belt tension. ... Additional parts need: F693ZZ 2x psc.

A termination for gt2 belts that I designed for my printer.

Simple and secure GT2 belt coupler! ... I'll make a half link version later.

just a small gt2 belt holder use 3mm screws to tread though

Yet Another GT2 Belt End Lock. Use the groove for a cable tie. ...

This is simple GT2 belt fastner. ... This needs small cable tie.

Two dimensional mount for GT2 belt (6mm) for TRONXY p802. ...First 5mm thickness, second 3mm.

This is a simple GT2 belt tensioner. ...It uses a M3 bolt and nut.

One thing to tighten a GT2 belt with (5.1mm hole) 50mm long 8mm width.

I needed a way to connect GT2 Belts for my Alexa Automation Curtains.

GT2 Belt Locker. ...Solid file attached so item can be easily edited.

GT2-Belt Tensioner for Y-Axis -up to 9mm adjustable with a M4 screw Have fun and share your makes

Belt connector for joining 6mm wide GT2 timing belts around large pulleys (>60T), inspired by [this thing](https://www.thingiverse.com/thing:1522234). ...Sides are reinforced to prevent failure from the tighter fit necessary for GT2 belts.

The file is for one half of a GT2 belt tensioning set. ...The part has a zip tie slot in it to bring each belt mount together.

This is a accurate GT2 Belt profile. ...I spend half an hour searching it without success so i thought it might be usefull.

Bought a roll of GT2 belt, needed a dispenser for it. 15% Infill, flat on the plate, needs 1 M3x6mm screw. ... It sizes at a 105mm diameter.

GT2 Belt Lock Inside hole 2.3mm, optimum 2.15mm Adjust scale to your printer tolerance, if your printer is exact print 93,5% scale

GT2-belt-pulley

This is just a remix of jman's design, I've updated the SCAD file and included an STL file, suitable for GT2 belts.

GT2 timing belt clamp, 2mm pitch and 6-10mm wide, with 4mm mounting hole.