hexbright 3d models

A stand to hold the hexbright flashlight upright. Instructions The OpenSCAD file is semi-parametric. Most of the design can be easily tweaked, but there are a few "magic numbers" scattered -- trig...

A stand to hold the hexbright flashlight upright. Print instructionsThe OpenSCAD file is semi-parametric. Most of the design can be easily tweaked, but there are a few "magic numbers" scattered -- trig laziness took hold.</p> <p>As rendered it is...

One design flaw (sort of) is that when the hexbright is inserted in or removed from the station, the o ring rubes up against the slot. It doesn't damage the o ring at all but I'm sure if you twisted and turned the hexbrighnt while its in the...

A handlebar mount for the hexbright flashlight. The hexbright just snaps in and is held very securely. I've been riding with it for a week in NYC and haven't had any problems with it coming loose. Two zipties and a piece of old inner tube make the...

This is a tool for removing the lens retaining ring on the business-end of a HexBright FLEX programmable flashlight, similar to the official HexBright FLEX Tool. The lip prevents the plastic from coming into direct contact with the TIR lens,...

If you don't know what the Hexbright is, it's a fantastic rechargeable flashlight that's Arduino powered:http://hexbright.com/ Here is a video of the latch in action:https://www.youtube.com/watch?v=tDSmgnrixQs Instructions I printed this with a...

Instructions Also have a look at my Hexbright firmware: https://github.com/alpharesearch/Hexbright For some reason I had set the scale to 50% in slic3r? I'm not sure why. But the tool worked for me. ...I was able to open the front and clean some...

An openscad implementation of lpercifield's hexbright handlebar mount. I made the upper edges a little beefier because the original cracked when I inserted the flashlight. Should be easily customizable for handlebar diameters other than 32mm.

I lost the spacer that came with my Hexbright flashlight, so I created a new one in Solidworks and replicated the original as closely as possible. I have tested this model with a Formlabs Form2 printer and it fits perfectly. ...Print Settings Printer...

I designed it to hold my HexBright flashlight onto one of the posts of my bed so it is in easy reach at night. The unit can fit any circular flashlight up to about 40mm in diameter. There are 2 holes running through the back meant to use zip ties to...