hglrc 3d models
514 3d models found related to hglrc.thingiverse
This is a puck surround for the HGLRC GPS. I needed this because the model I was installing the GPS on did not have enough thickness of foam to french it into the foam. ... I included a 2nd STL with a slot to run the wires out the side in case...
thingiverse
HGLRC Sector30 Propguard - CineWhoop V.2 By VONGUZA FPV PRODUCTION for fpv frame HGLRC SECTOR30 OR SECTOR150
thingiverse
Just my design of a Insta360 Go camera mount for the HGLRC Sector 132. ...Super Simple.
thingiverse
instago 2 quick and dirty tinkercad adjustable mount for the hglrc sector v5
thingiverse
HGLRC GPS Strap Mount. The holes on the sides are for zipties to secure the connector cable from being tugged. ...
thingiverse
Standard GoPro mount for HGLRC Sector 150. ... If you appreciate this buy me a cup of coffee: http://paypal.me/MScardi
thingiverse
TPU parts for the HGLRC 145mm quad. Shark fin with sma mount. antenna tubes (long part holds forever tubes, short part goes on the standoff), and wire protectors. ...
thingiverse
HGLRC Batman Sharkfin (6gr) i just received this frame and wanted to make some parts for it. next in line will be a camera protecting in the front, capacitorholder in the back and antennaholders. ... if there are requirements to adjust some files...
thingiverse
Camera supports for the HGLRC Sector 132. They provide a 'chin' to the front to give some protection to the camera. Made for the 4K Version (Tarsier), don't know if it fits other versions. Printed with TPU, no supports. They are joined together...
thingiverse
this is a canopy for the HGLRC petrel 120, the ABS one it came with cracked pretty damn easily so I made a TPU version, fixed at 35 degrees camera tilt, prints in about 2 hours running at 30mm/s, originally had it at a 2mm wall thickness but decided...
cults3d
Some FR7-style mounts and Gopro mount for the HGLRC Sector frame I did will moving from Tinkercad to Fusion 360 Micro buzzer (9mm) standoff mount Tail mount for SMA, antenna tubes, BN-180 GPS, 9mm buzzer Tail mount for SMA, antenna tubes, BN-180 GPS....
thingiverse
Sharing the printable files for HGLRC Sector 150. Two versions of the Naked GoPro is available, a fully covered one and a betafpv-style band at the middle. The XT60 holder is quite a tight fit but workable. No problems pulling or plugging the...
thingiverse
Some FR7-style mounts and Gopro mount for the HGLRC Sector frame I did will moving from Tinkercad to Fusion 360 1. Micro buzzer (9mm) standoff mount 2. Tail mount for SMA, antenna tubes, BN-180 GPS, 9mm buzzer 3. Tail mount for SMA, antenna tubes,...