holder a 45 3d models
2367718 3d models found related to holder a 45.thingiverse
Userful to keep wires organized in BOSCH frames. ... Instructions It has a thin base just to improve printing quality. Just cut it out after printing and you are done. ... Print it with 3-4 perimeters.
thingiverse
... too tight og too lose, therefore I made this (pliers) derivative. Instructions print settings: 3 walls 50% infill To fit the straw in the holder.... remove holder from the can and give the big ring a little squeeze.... ...slide the straw in place.
thingiverse
this is a Toilet paper roll holder with a 45° angle for mounting on coner´s
cults3d
this is a Toilet paper roll holder with a 45° angle for mounting on coner´s
thingiverse
A feeding tube holder re-designed with a phone holder and a 45 degree angle
sketchfab
Cruz redonda a 45° en lamina galvanizada. Figura en 3D dibujada por Ing. ...Enrique Aceves.
thingiverse
Agujero a 45° de inclinacion Grosor maximo de mecha: 0.6 mm Largo minimo de salida de mecha: 50 mm
sketchfab
Another day that proved to be above and beyond just a simple prop. There is not much to work around this word than just straight up protraying it. ...Today’s word, “Sheep.
thingiverse
It's a simple tool for determining the angle of 45 degrees. ...Useful in the workshop.
thingiverse
This is the first Version of a HK 45 Mag Holder for .45 ACP Mags The STL includes the Body with is stockable and the end covers. If you have any ideas how to improve please let me know. ...
thingiverse
This is a microphone holder for putting two Shure SM57s in a 45 degrees angle. It can be mounted on a normal mic clip. ...Be sure to check the measurements on the attached screenshots for scaling
thingiverse
Filament holder for Sculpto filament 45 mm wide = 40 mm wide rolls
thingiverse
Drill holder designed for 45° angle for 4mm drill. ... Maybe you need to adjust mesh scale x10.
thingiverse
45° spool holder for Ender-3/pro Use only support touching buildplate ! ... Nozzle température : 200°C Bed Temperature : 50°C Resolution : 0.12/0.16mm
thingiverse
Shower Head Holder. 45* angle. use suction cups in the back to hold it to the wall. Print as-is. ...no supports needed.
thingiverse
A fixing a clothes rod at a 45° angle in a 90° corner. ...For 28mm clothes rod.
thingiverse
... vertically. I designed this because I had problems with a new shower head wich has a too small angle by itself so it was too upright with my old shower head holder. ... You can check the dimensions of my shower head on the last 3 photos :)