i phone tripod 3d models
1223156 3d models found related to i phone tripod.thingiverse
This is a easy to print, assemble and use phone tripod. Part list: 4x 20mm M3 screws and nuts 2x foam and glue 1x rubber band Printer settings don't matter too much. ...Note that I have a cheap printer, you can get way better results with a...
myminifactory
This is a easy to print, assemble and use phone tripod. Part list: 4x 20mm M3 screws and nuts2x foam and glue1x rubber band Printer settings don't matter too much. ...Note that I have a cheap printer, you can get way better results with a decent...
prusaprinters
... You can put a small amount of grease on the very end of the bolt for smoother operation.Originally published in 2020: https://www.thingiverse.com/thing:4181527 Print Settings Supports:YesResolution: 0.20 Category: Mobile Phone
thingiverse
Simple phone tripod. I chose to use metal hardware- all 1/4-20 threads - but printed 1/4 fasteners could be used, too. ... --- ### Filament ##### Checkout the black filament used...
thingiverse
A tripod for your phone so you can take videos or long exposition pictures. There are 2 different legs, short/long. There are also 2 different holders. One uses m3 screws/bolts and you will have to print the stops so the hardware does not...
youmagine
"Iphone6tripod.stl" will accept phones sized 65mm - 70mm (iphone 6/6s/7, galaxy s4, htc one, blackberry z10, nexus 4/5). "Iphone5tripod.stl" will accept phones sized 59mm - 64mm (iphone 4/5/5s/se). if you have a case make sure to measure. only tested...
thingiverse
- Use a screwdriver to slightly widen the gap of the Tripod Base ball joint and push the phone clamp in place. - Side the M5 bolt through the printed screw. If it's difficult to get the last bit of the bolt head seated, use an M5 nut on the other...
thingiverse
Check @Electro_Dreams out here: https://www.instagram.com/electro_dreams/?hl=pt I also have this tripod changed for the GoPro cameras, just check my profile and you will find it. As always if you have any opinion about my creations and possible...
prusaprinters
A simple phone tripod for photography.Notes: Use 3 perimeters for the Base.stl. ...The others are fine with 2.Orientate the parts correctly to avoid need for support (the default position is not correct for a few parts...apologies)BOM4 x M3x18mm...