inspiration ccr 3d models

A 9/16" male UNF dust cap with a hollow to allow it to fit on a low-pressure regulator hose. ...Designed as a dust cap for the inspiration vision rebreather solenoid LP hose and BOV LP hose.

CCR

Customized version of http://www.thingiverse.com/thing:74322 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=74322 Instructions Using the following options:...

Customized version of https://www.thingiverse.com/thing:714444 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=714444

Highly detailed exterior and interior of the Koenigsegg CCR.

Clip for Triton CCR

Retaining clip for the JJ-CCR

HUD holder for the Triton CCR.

ADV Extraction tool for the ISC MEG CCR

Porte cellule pour CCR joki, se place directement à côté des deux autres cellules.

3D model from the M64 Nut on the counter lung of the triton ccr

A spring cup/guard designed to prevent the tires from tangleing in the spring on a Losi CCR

a rough koenigsegg CCR rim. ...sort of a little hint as to what i am currently trying to make :) modelled in sw 2011

A tool to aid in the fitting and removal of the IQSUB X-CCR rebreather battery cap. ... This little tool will save you £30 for the 'official' one.

Customized version of https://www.thingiverse.com/thing:3045130 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3045130

Replacement Cable Holder for JJ-CCR HUD/Controller. Useful if you get a DiveCan Nerd or similar that does not have this part factory fitted. Screw into place and close with cable ties. ... v1.12 has a 1mm larger ID than previous version in the...

This shroud fits between the OPV and the head on a KISS Sidewinder CCR and helps prevent accidental dumping of gas from the OPV. I was tired of knocking the OPV and having it unscrew a bit or vent but didn’t want to plug it so I made this ‘cover’...

INSPIRATION GLOBE

Pre-supported Inspiration coin for DnD

3D model by inspiration of Artemide CATA (none identicaly)

this is an Inspiration token for DnD 5e

An inspiration token to give your players when they gain an inspiration point in D&D 5e.

3D model of Koenigsegg_CCR

Wallmount for JJ-CCR-Loop

3D model of Koenigsegg_CCR

Funnel for CCR Liberty scrubber

Some Inspirational words to use as art, or a stamp. ... The dot in the I's are not attached.

Just a simple token for inspiration, made for my D&D games. My first 3d creation! ...=) Made it in TinkerCad.

... with Tinkercad. ...Edit it online https://www.tinkercad.com/things/eX4w9NKTKfD. Features an embossed star and #1 on the first side, and is blank on the back. Useful for Inspiration (in D&D 5e), or tracking special attributes in RPGs, board games, etc.

http://www.thingiverse.com/apps/customizer/run?thing_id=47484 Instructions Using the following options: rim_height = 2 Top_Text2 = Inspiration Top_Text1 = D&D Bottom_Text2 = Bottom_Text1 = Use me Well TopSide = 1308 height = 2 radius = 18 rim_thick =...