ipad on stand 3d models
1277632 3d models found related to ipad on stand.
thingiverse
this brackte designed for Ibad pro with the monitor stand
thingiverse
for iPad mini A (non Retina Version) intend to clip-on, so slot is tight fit (7.25mm) works as Portrait and Landscape stand. Landscape with two tilt-angels. if you hold it in your Hand put fingers in the holes to get a save and good grip! :P have...
myminifactory
... so it doesn't use a lot of filament or take up a lot of space. The tablet is simply placed into the centre of the stand. It angles up at the back approx. 26 degrees which seems to be about the angle most users find comfortable for use on a desk.
cults3d
... so it doesn't use a lot of filament or take up a lot of space. The tablet is simply placed into the centre of the stand. It angles up at the back approx. 26 degrees which seems to be about the angle most users find comfortable for use on a desk.
thingiverse
Instructions Prints well on a Replicator 2 with Raft, 4 shells and 20% infill at 0.20mm (Std) resolution. No supports are required. However, as some angles are near the limit for PLA to print out unsupported, the lower / underside edges of some...
thingiverse
Customized version of http://www.thingiverse.com/thing:512350 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=512350 Instructions Using the following options:...
thingiverse
i personally find that the best position for writing and drawing on a tablet is a slight angle of the tablet. since i have not yet seen a holder for this that goes quickly to print and also takes up little space (keyword transport) i quickly...
thingiverse
... into the mirror mount. Here is a link to the [Fusion 360 Model](https://a360.co/2P42koY) Parameters are present for adjusting the stand and mirror to more accurately fit your iPad case and adjust the mirror size if you can't find 1" sqaure mirrors.
cults3d
... connection to the DJI Inspire 2 controller. Design to add non-slip adhesive grip for maximum grip on the Ipad - Tablet. Total satisfaction guarantee! ...Designed and tested by drone pilots to enhance the functionality of the DJI Inspire 2 Drone.
grabcad
... I changed a little bit the design and made it cut on a laser cutting machine. ...I use 3mm clear Acrylic... i made all my colleague jealous with my iPad standing on this support on my desk, i use my iPad like a picture frame, fantastic !