iphone 5s stand 3d models
186382 3d models found related to iphone 5s stand.thingiverse
iPhone 5s camera stand I made to fit my glass desk that is .390" or 9.91mm thick. ...Print Settings Printer Brand: Wanhao Printer: ...
thingiverse
Here's another iPhone stand/ sound amplifier with room for a small phone case.
thingiverse
Printed 0.2 nozzle has a perfect fit over the antena, only sand a little bit the cilinder base https://www.thingiverse.com/thing:214436 work with this stand but iphone 5s must be with protection case in it. ...
thingiverse
I wanted to try and make a stand to hold my phone on my desk while i worked, that would hold it at the angle I wanted, while pushing the sound in my direction. This was my second try, challenging myself to use as little material as possible. ...
thingiverse
Customized version of http://www.thingiverse.com/thing:512350 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=512350 Instructions Using the following options: _length...
thingiverse
iphone 5s stand with 15 degree for better viewing
thingiverse
A simple stand and charging dock for iphone 5s with. Amplifying cut outs for the speakers. Holes for weights, Makes for a premium feeling (use 10pcs of m4 20mm) Cut out for charging cable (Made it to fit the cable without the plastic cover.
thingiverse
Print 2 Phone Holders and one Linkage Beam. Assembly is straight forward, glue is required. It is used to elevate your phone so that your flashlight can shine down on pages, scripts, etc. in dark areas. This was designed for sound/lighting crews a...
thingiverse
I made this to fit my iPhone 5s on a tripod, just print it and glue the base to the case and screw it onto your tripod Print Settings Rafts: Doesn't Matter Supports: Doesn't Matter
thingiverse
Lateral / Landscape Mode Version with 0,5mm Case or without Case! i printed it with 2,5mm "glow in the dark green" and then white. In Darkness its nice! ...See Picture Printed with PLA from 3Druckstore.com
thingiverse
This clip onto 2*10 plank and holds the IPhone at a 15 degrees angle.
thingiverse
Customized version of https://www.thingiverse.com/thing:2367305 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2367305
thingiverse
horizontal and vertical This is my Version of iPhone 5 / 5S stand. Its fit's perfect, horizontal and vertical. There is a opening for speakers. ...Printed in 25 minutes @0.25mm layer with 125mm/sec V1.6 with rounded Home Button Hole I printed it...
thingiverse
Iphone 5 and 5S stand Instructions I printed this iphone stand at a Makerbot Replicator 2 with 10% infill, 2 numbers of shells and 0,25mm layer height.
thingiverse
A stand made for the iPhone 5, 5s, and 5c. I made enough room on the front end in case you are using a thick case like an Otterbox. ...Print Settings Rafts: Yes ...
pinshape
Summary A stand made for the iPhone 5, 5s, and 5c. I made enough room on the front end in case you are using a thick case like an Otterbox. ...Print Settings Rafts: Yes Supports: Yes Notes: Print on its side for better strength.