ipod 1st generation 3d models
81332 3d models found related to ipod 1st generation.thingiverse
The firewire port was at the top at the time, and Apple hadn't created the dock for the iPod until the third generation of iPod with the introduction of the beloved (maligned) 30-pin connector. Similar dimensions to the iPod Universal Dock for iPod...
grabcad
... lineup was retired after a long and successful run , but we at The Silent Canvas decided to bring one back to life on the eve of #throwbackthursday . ...Presenting the iPod nano 3rd generation, modelled as accurate to measurement as it was possible.
grabcad
This is an attempt at an exact replica of the iPod Touch 5th Generation. ...I attempted to make everything from the retina of the camera to the loop and the charger as close as I possibly could, even with the camera having depth to it.
grabcad
... model when I was designing the PodKit Watch. ...It is a dimensionally accurate model of the 6th generation iPod nano. ...I can verify this because I built prototypes of the PodKit Watch from this data, and the real nano perfectly fits my prototypes.
grabcad
Portfolio Work - Step file contains headphones and iPod (Case not included)
grabcad
I really hope you guys like this iPod touch ,from a high school student
pinshape
This is a basic customizable iPod 5th Gen. case. You can edit it to make it more personalized for you. ...or just use this case.
cults3d
(1st Generation) The low bypass engine seems to refer to an engine having bypass ratio of 2 or less. Bypass ratio of this model is less than 1. This type of engine is ducted over the entire length of the engine, making it difficult to assemble. A. ①...
thingiverse
It's a sports case for a 1st gen ipod touch, you can add a wide rubberband on the back to wear it on your arm or the like. I've Included the freecad model if you want to modify it. ... Instructions Just...
thingiverse
I first made an exact model of the Ipod using drawings supplied by Apple. Then I designed the case around it in Fusion 360. I was very pleased with the first print. It was a perfect fit! Of course, she wanted #selfie on her case, so I've included...
thingiverse
Stand for 6th generation iPod Classic. ...Fits 120 GB and thin back 160 GB models.
thingiverse
This is a case for an iPod Nano of the second generation designed by Apple in California. ...It consists of 2 parts, a top and a bottom.
thingiverse
This is a quick stand I made for my 2nd generation iPod. ...It has a notch in the front so the wheel, and buttons, are not covered.
prusaprinters
A simple and clean iPod touch case. ...The case was designed for the 7th generation iPod touch but but will also work with generations 5 and 6 as the dimensions are the same. ...Printed in PLA with no supports.</p>