jumper header 3d models
7526 3d models found related to jumper header.thingiverse
This design creates a passable jumper connector. By fiddling with the parameters the number of pins can be adjusted and the pins can be resized to fit better. ...The default parameters work well enough but may lose contact if the wires are jiggled too...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=1676508 Instructions Using the following options: units = 25.4 wire_diameter_in_units = 0.04 inner_width_in_units = 0.06 height_in_units = 0.5 reinforcement_in_units = 0.02 wire_jut_in_units =...
thingiverse
Customized version of https://www.thingiverse.com/thing:1676508 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1676508
thingiverse
Customized version of https://www.thingiverse.com/thing:1676508 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1676508
thingiverse
I managed to design a jumper that goes in between the base and the camera lid for the original rpi zero case to give it enough space for nothing to be touching. I think the tolerances can be lowered a bit, but I ended up using the kind of double...
thingiverse
I started out with a plan to create a Raspberry Pi 3 GPIO header cover with customizable cut-outs for jumpers. The idea was to only expose the pins that are needed and protect the rest. In the end i have a fully customizable header cover with jumper...
prusaprinters
The idea was to only expose the pins that are needed and protect the rest.In the end i have an scad fully customizable header cover with jumper cut-outs. In addition to being able to select the pins to cut-out for jumpers, you can set the number of...
thingiverse
Customized version of https://www.thingiverse.com/thing:3962634 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3962634
thingiverse
Customized version of https://www.thingiverse.com/thing:3962634 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3962634
thingiverse
Customized version of https://www.thingiverse.com/thing:3962634 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3962634
thingiverse
Customized version of https://www.thingiverse.com/thing:3962634 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3962634
thingiverse
Customized version of https://www.thingiverse.com/thing:3962634 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3962634
grabcad
Headers are one of the easiest bolt-on modification. ...It helps in eliminating the manifold back-pressure.
grabcad
Header 1pin, 2pin, 3pin, 4pin, 5pin, 6pin, 7pin, 8pin, 9pin, 10pin 11pin, 12pin, 13pin,14pin, 15pin, 16pin, 17pin, 18pin, 19pin, 20pin.
thingiverse
My 2D poster of gambling character at [QQMEGA368](https://bandarbolajakarta.com/) its from Gates of Olympus and Hammer of Thor, looking forward to make it 3D if I have the printer