k50 laser 3d models

Chinese laser cutter K50 (50W)with table made of 4040 aluminium profileswith chiller (CW-3000)with exhaust system BOFA Access

Visaton K50 Loudspeaker

K50 model with basic interior layout.

Capacitor K50-35 dim 16x26 mm

Miele K50 Emblem für das vordere Schutzblech.

After my original powerbank K50-SW from Aldi got slipery (rubber) outside, I decided to change the case. Here is the result. There is an upper and a lower part. Enjoy it. ...

I took the 30mA version from Amazon https://www.amazon.de/gp/product/B07VJ3GYPS?th=1 I made 2 parts: - Bottom part (Unterteil_V1.3mf) - Top part (Aufsatz_V1.3mf) The bottom part can be screwed with 2 M4 screws to the K50 and holds 2xM3 nuts The Top...

Ersatzrollen für den Kärcher Akku-Besen K50.

No description provided.

Adaptor from K50 DIN 69871 to Morse 3

No description provided.

Simply a 38 Sp Revolver

Cover for K50 aluminium extrusion profiles as used on the SFX-100. Gives the profile a nice look and protects from dust. Can be pushed in before assembly of the actuator or snapped in later on. ...But be careful, it's quite thin and too much force...

On my BMW r1200gs lc k50 had Need Full Bunker Exclusive crash bars were installed. After that, the mounting block of the original fog lamps could no longer be installed, its place was taken by the mounting of the upper arches. Hinged mounts of...

*DO NOT PAY MUCH ATTENTION TO THE PHOTOS* I modified the top part and a few other things, its basically the same thing but with no holes on the top I made this case for my LG K50, but cases for this phone are sold for both this one and the Q60, and...

Laser

Laser

A laser of laser pointer.

hand laser model

Laser Gocator 272 mm

3d model of laser beam.

First version of a bracket with a clamp to hold a laser.

A model of a laser that I've used at work...modeled it with dimensions guessing from a picture. ... It was pretty fun to make.

I needed a smaller M6 to M3 from insertion on K45-50 aluminum extrusion. ... I had used a original M8 as model.

A wall mount for the Topcase of the BMW R 1200 GS LC K50.

Da sich das große Puig Windschild bei schnellerer Fahrt ohne Verstärkung des Halters sehr schnell verformt, habe ich nach einer Lösung gesucht welche sich schnell umsetzen und ohne größere Modifikationen des original GPS Haltebügels anbringen lässt....

Because the model is small, some modifications may be required in some cases. ... Please feel free to improve it if you need to modify it.

Made in Solidworks Rendered in Keyshot

Laser assembly (Laser leveller)

Abdeckung für 3D Laser