kakute f7 flight controller 3d models

Protective cover for Kakute F4 AIO to protect IMU. Also practical to have additional surface to mount receiver with double sided tape. ... Print from clear filament to see LED-s on the board.

Holybro Kakute F7 Flightcontroller

Cap for the amazing Kakute F7 AIO Protect your Gyro guys! ...

supporti per il montaggio di flight controller kakute f7

Omnibus F7 V2 Flight Controller Case

DJI Naza -M V2 main controller

i made this for my controller, had a screw down type camera clamp and wanted to put it on my bwine f7 drone controller. i left the hole out on the bottom, so youll need to drill your own 1/4 inch hole. this adapter fits into the sprint loaded holder...

COVER FOR FLIGHT CONTROLLERS

rc car flight controller

flight controller rc car

rc car flight controller

flight controller mount

Autoquad Flight Controller Update

AutoQuad Flight Controller Update

AutoQuad Flight Controller

F4BY flight controller case

Simple "wall type" gyro wind protection. I'm using Reversed Props, what genereates whirlwinds that can disturb gyro work and protect electronics from grass and dirt. There is also battery belt gap. ... Editable *rsdoc files are included - you can...

Flight Controller 30.5x30.5x1.2mm protection.

Adapter for your Flight Controller.

The Drotek PX4 open hardware flight controller

Simple flight controller mount for using miniquad FC's for fixed wing flight controller purposes.

This is a model of the Pixhawk Flight Controller

Model of the Rabbit flight controller for design.

Basic geometry for CC3D flight controller and plastic base in two parts.

This is the KK2.1.5 LCD flight control board mostly used for FPV racing drones.

Protective case for the BrainFPV (brainfpv.com) flight controller. ...Designed to mount directly to standoffs, thus no bottom section.

This flight controller base has posts that are 30 X 30 and uses a 2.6mm screw

This is a CAD of the Pixhawk PX4 Flight Controller for you to use in your drone CADs!

Fully accurate 20x20 flight controller, with gummies! ...A single body in a .step format for you convenience.

This flight controller base has posts that are 30 X 30 and uses a 2.6mm screw