keyswitch puller 3d models
1475 3d models found related to keyswitch puller.grabcad
This is a rubber boot to keep water from getting on the back of the keyswitch
thingiverse
A little stand to display your keyswitches. ...Holds 4 but if this gets more attention I will make ones with more slots and ones that stack.
thingiverse
The KeySwitch is a low-cost AT Switch Interface to allow a user to send keystrokes and mouse movements by activating external switches. There are two tops - one has the ATMakers logo embossed on the underside, but that will only look good with...
prusaprinters
This is the housing for a KeySwitch Interface by ATMakers.org. The KeySwitch is a low-cost AT Switch Interface to allow a user to send keystrokes and mouse movements by activating external switches. There are two tops - one has the ATMakers logo...
thingiverse
This is an extended "puller" for the flying helicopter toy http://www.thingiverse.com/thing:1885007/ I printed the helicopter at 50% size and the puller was a bit short. ... This puller is sized for 50% of the original.
thingiverse
puller made with solidworks bolts not included also id love to see a picture of one of these made and working
grabcad
Puller, actually a hanger for various mass weights, like the 4lb I had uploaded earlier. ...3d printed, works great and is light weight
thingiverse
Puller for size 80x35 mm. Need thing more screw M4x8 mm. ... Specification 001 - 1 002 - 2 003 - 1 004 - 2 005 - 1 (14 mm) 006 - 1 (22 mm)
thingiverse
Keyswitch opener Cherry&Kailh Other made →http://blog.livedoor.jp/tureduremake/
thingiverse
This holder hosts up to 24 keyswitches, holding them securely ## Usage The keyswitches click when placed in the holder. While they can be removed by grasping either side, it's even easier to grasp opposite corners. ## Printing It works well to...