klipsch headphones 3d models
14514 3d models found related to klipsch headphones.thingiverse
Mounting rings for the few people that own the Klipsch HP-3 headphones! These headphones are beautiful and sound great but the original pads are hard to come by so I've designed these myself! You'll need: 6 pieces of Ø8mm x 2mm thick neodymium...
thingiverse
This is the set of parts for the replacement of one Klipsch Image ONE (II) Headphones hinge. In addition to the 3D printed parts, a pair of #4 (.112-40 UNC) X .50 long screws, nuts (3/32" thick and 1/4 wide) and the original hinge pin are required.
myminifactory
A larger volume knob for Klipsche promedia pc speakers. ...Simply press fits opver existing tapered knob.
thingiverse
Larger knob for Klipsch promedia PC speakers, simply press fits over existing knob.
thingiverse
Whether the lens is really needed for a Klipsch K-402 horn is something everyone must decide for themselves. ...The influence on the sound conduction is maginal, it is to strengthen the brilliance in the high tone.
thingiverse
Print this protection for your Klipsch SPL-120 subwoofer! The file is one half. So you have to print twice, and in mirror to get one piece. Printed on the small side (see picture) to reduce the amount of support. ... Soldered the two pieces togheter...
thingiverse
Klipsch RB10 to Atmos wedges. It is what it is. Works for me since they were extra. Idk what's wrong with my Fusion exports, but I always have to print everything at 2540%. ...Flip and lay flat in your slicer.
thingiverse
I some how lost one of the stamped steal stands for my Klipsch Promedia 2.1 speakers. Armed with 123D Design and a 3D printer I made a new stand that I liked so much I printed two. These stands are a shorter and don't stick out the back as much as...
thingiverse
... substantial, so I made this case with a little loop for securing a lanyard to. Now I can just grab the lanyard and pull the remote to me. I designed this for the remote that comes with the R-15PM's but I think it will work with all Klipsch remotes.
thingiverse
This is a replacement foot for the Klipsch RF-15 floorstanding speaker. It probably works on other models too, but that hasn't been tested. I accidentally snapped one of the originals in half when moving it around, and there didn't seem to be any...
thingiverse
This is a desk mount for the Klipsch ProMedia 2.1 speakers. It is designed to be used with desks 1" thick. The mount has an interference fit on the desk corner and is angled at 45°. I've designed it to be rigid enough to not wobble if your...