kobalt router 3d models
15312 3d models found related to kobalt router.
thingiverse
Kobalt Router Table Ring was a replacement for the missing piece of my router table. ... You may have to do some fine tuning for this item to fix snuggly in.
thingiverse
Replacement router table inserts for the Kobalt Router Table. They fit better than the originals. About one hour print time per insert. Printed at .2 layer height and 50% fill. Center hole sizes match the OEM inserts: Small 1-1/4" center hole Med...
thingiverse
Push block for the Kobalt router table. The included push block was quite loose in the track and this is a nice tight fit (on mine at least). ...I also made a positive and negative 15 degree block since I seem to use those angles quite a bit in...
thingiverse
This is a first attempt at making a tool holder for the Kobalt Router table. It is printed in two parts to avoid using supports. The pieces will be bonded with glue. This holds two inserts, the 1/2" collet, the starting pin, wrench, and lift allen...
thingiverse
This plate is to be used when the router is attached to the router table. ...It allows the router tables dust collection port on the fence to function as intended as well as allows the use of the height adjustment key.
thingiverse
The knobs to adjust the fence on my router table were difficult to get to so I made these knob extensions that are a lot easier on my hands. I included built in supports so no slicer generated supports are necessary. ... Printed in PETG so it...
cults3d
The knobs to adjust the fence on my router table were difficult to get to so I made these knob extensions that are a lot easier on my hands. I included built in supports so no slicer generated supports are necessary. ... Printed in PETG so it won't...
thingiverse
1.25" (31.75mm) ShopVac to (2.5") Kobalt Router Table The 2.5" end will go inside the piece and the vacuum suction will keep it attached. There is a ring to stop it from going in further. ...I designed it quickly to connect my 1.25" shop-vac hose to my...
thingiverse
A coworker asked if I could make him a replacement emblem for his Kobalt toolbox. This is what I ended up with. ... Who knows, maybe someone will find it useful :)
prusaprinters
Organizer for Kobalt midget wrench set. Print instructionsOrganizer for Kobalt midget wrench set.
sketchfab
3D scan using Artec Spider of new Kobalt XTR Reciprocating Saw (without battery).
thingiverse
Designed for my shop as no other battery holders were out there for the Kobalt 24V.
thingiverse
Latch for Vacmaster VWMB508 . ...This was rebranded at Lowes under Kobalt label. ...
sketchfab
3D scan using Artec Spider of new Kobalt XTR Impact Driver (without battery).
cults3d
Made a quick battery holder for my extra Kobalt batteries. ...Enjoy
thingiverse
This is a little something I whipped up to hang my 24v Kobalt tools from the underside of a bench, or in my case some cabinets.