life link snow saw 3d models
171443 3d models found related to life link snow saw.thingiverse
Snow saw handle to replace the piece of heat shrink tubing that served as the original handle on the Life-Link® snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed). The...
cults3d
Snow saw handle to replace the piece of heat shrink tubing that served as the original handle on the Life-Link® snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed). The...
myminifactory
Snow saw handle to replace the piece of heat shrink tubing that served as the original handle on the Life-Link® snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed). The...
thingiverse
Track links used for scx10 snow tracks Modified the holes to use 2-1/2 in finishing nail Modified the thread for better traction use support only touching buildplate and print upside down
sketchfab
Remake of the Water of Life from Zelda 2: The Adventure of Link.
thingiverse
for use with rc snow track Champagne Yeti track this link use less of material TPU and more lightweight can be linked with nails of finition 16 ga 2 1/2 length or for not so powerfull truck like as crawler 1/10 with stock motor you can use carbon...
thingiverse
Found the traction wasn't the best for these tracks, extended the nub to increase traction in snow/sand. Also angled it if you feel it is necessary but I have found the straight one is the best overall. Made a bit taller one and one that is much...
pinshape
This is the Zora Link's guitar in Legend of Zelda : Majora's Mask. I tried to make it realistic. Total lenght : ~50cm My Printing settings: Support: Yes Speed: 30mm/s - 50mm/s Layer: 0,1mm - 0,15mm Infill: 10% Painting: Acrylic paint
thingiverse
This is a PLA, 3d printable version of the Life-Link snow saw, which I could not find available for purchase at this time. It seems illogical to print a saw, but considering the media, I gave it a go. The two pieces are held together by a zip-tie,...