lightsaber pvc 3d models

15922 3d models found related to lightsaber pvc.

Darth Vader Lightsaber PVC Kit
thingiverse

To get a realistic metal surface, carefully wrap the PVC pipe in aluminum tape and then rub it down with a pen to get out the wrinkles. I then took rough cloth and rotated the pipe in it to give it a brushed look. Included in the files is a grip...

PVC Lightsaber Parts
thingiverse

Various lightsaber parts designed to fit over sch40 1" PVC.

PVC Lightsaber Hilt
thingiverse

A lightsaber hilt to fit around 1 inch PVC pipe.

PVC Lightsaber Chassis
thingiverse

Electronics chassis for PVC lightsabers. Designed to hold an 18650 3.7V li-ion battery, small soundboard (NBv4 and Pico Crumble), and a Veco 20mm speaker. ...

Banished Sage PVC Lightsaber Parts
thingiverse

These parts are made to be slid over a 1" ID PVC pipe.

1in SCH40 PVC lightsaber hilt PCB adapter
thingiverse

I used a 8/32 x1/8" set screw threaded into the PVC pipe to hold this in place. The slot in the center is so that the PCB can be removed without removing the adapter. ... Designed for this PCB though I believe most to be the same OD:...

Lightsaber hilts for pvc pipe sword
thingiverse

These are made to slide on to 22mm (1/2") pvc pipe. I put pool noodles over the pipe and use it as a dueling sword. The sabers are in three parts, so you can mix and match to your liking. Please enjoy! ... -RoR Edit- made saber middle 1 150mm long...

Child Size Lightsaber Hilt for 3/4 in PVC Pipe
thingiverse

Designed with sort of a lego star wars look that will fit 3/4 in PVC pipe in it with the assistance of spray foam. ...When scaled at 95 percent, it will be so snug, you won't need to use spray foam although it is always recommended.

Lightsaber - uses 3/4 PVC - prints without support - Star Wars L
pinshape

SummaryThis is a lightsaber I designed for this years Halloween. Check out the video to find out how to bring this thing to life. ...https://youtu.be/6dkSYYaRvcE

Initiate V4 Lightsaber Hilt (Ultrasaber Hilt for 3/4 PVC Pipe)
thingiverse

Designed to be a whole lot like the Ultrasaber Initiate V4 Saber. ... -I printed this at 70 percent infill. -3/4 in. PVC pipe was used for the blade. -Blade tip was superglued on. ... -Spray foamed right before pommel is put on to balance the Saber.