logiteck k330 3d models
19 3d models found related to logiteck k330.thingiverse
A replacement tilt feet for the Logitech K330 keyboard. ... Ein Ersatz-Klappfuß für die Logitech K330 Tatstatur.
myminifactory
A replacement tilt feet for the Logitech K330 keyboard. ... Ein Ersatz-Klappfuß für die Logitech K330 Tatstatur.
prusaprinters
This is a replacement foot for the Logitech k330. Print instructionsCategory: Computer Summary This is a replacement foot for the Logitech k330.
thingiverse
Se trata de una de las patitas de nivelación del teclado Logitech K330 que se me rompieron recientemente, imprime un juego y cámbialo por el que se te haya roto. ... ____ A keyboard leg exchange for Logitech K330 broken legs.
prusaprinters
This is a remix of the Logitech K330 keyboard feet. Original was a bit loose - this model is wider to give a solid, snug fit (you need to squeeze feet a bit to install them, like the injection moulded originals). ...Photos show 0.2 mm PLA - prints in...
thingiverse
K330 keyboard leg. ...Printed on my Ender 3 V2 with no supports and fits perfectly.
prusaprinters
Spare part for Logitech keyboard K330 Print instructionscan be printed w/o support structures using PETG at 0.2 mm
thingiverse
Pattes rallongées pour clavier Logitech K330
thingiverse
This is a replacement foot for my Logitech K330 keyboard. Very quick to design and seems to work well. ...May work with other Logitech keyboards.
thingiverse
... design that I have posted on here! I hope you like it! It's a replacement part mainly based on the Logitech K330. If it fits any other keyboard please let me know in the comments. ...I hope this helps and I hope it can fix your keyboard stand issue!
thingiverse
... keep the stuff you use the most along with it. This one was designed for a Logitech K330 so It has the notches for the ON/OFF switch and the battery lid. To glue it to the keyboard I used double-sided tape. 2 Version: 60mm and 80mm depth. ...
prusaprinters
Just so when you move your keyboard around you keep the stuff you use the most along with it. This one was designed for a Logitech K330 so It has the notches for the ON/OFF switch and the battery lid. To glue it to the keyboard I used double-sided...
thingiverse
The graphics card in this K330 was replaced with a gtx 1060 and due to the poor airflow the whole case became warm to the touch and cpu and gpu temps under load were getting too high. The handle comes off without too much trouble by bending back...
thingiverse
I designed it for the Logitech K330 keyboard, although I think it will adapt well to most keyboards, since it can be adapted to measurements between 15 and 18 cm wide thanks to the lower moving part, which fits the keyboard by means of a rubber that...
cults3d
I designed it for the Logitech K330 keyboard, although I think it will adapt well to most keyboards, since it can be adapted to measurements between 15 and 18 cm wide thanks to the lower moving part, which fits the keyboard by means of a rubber that...