lpfrg 3d models
11 3d models found related to lpfrg.thingiverse
Optimzed for the spools from lpfrg.com. Washer and Base is required for the regular spools with an inner diameter of 30mm. The Bigspool adapter is used for the professional PLA spools with an inner diameter of 53mm. ...
thingiverse
This one is designed to work with white spools as supplied by plastic2print.nl and Leapfrog (lpfrg.com). Maybe works also with other suppliers using white spools. The filament clips nicely in the clip, no need to 'feed it through'. 1.75mm only. ...
thingiverse
... print, imported the scan in Sketchup, refined. Bowie went from 2D to 3D, always ahead of his time. Instructions Printed on LPFRG dual Creatr, one perimeter, 2 bottom layers, 4 top, 25 % infill, 0,20 mm layer height. ...Print job 25 minutes.
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify 3D (https://www.simplify3d.com/) software.
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify 3D (https://www.simplify3d.com/) software.
thingiverse
I designed this EggBot using SketchUP and I printed the 3D parts using the Creatr Leapfrog 3D printer (http://www.lpfrg.com/). ... Instructions For this project you will also need Other hardware parts:...
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify3D (https://www.simplify3d.com/) software.
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify 3D (https://www.simplify3d.com/) software.
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify 3D (https://www.simplify3d.com/) software.
thingiverse
... for 3D printing using the Chimera software (http://www.cgl.ucsf.edu/chimera/) and saved using the .stl extension. It was printed on a Leapfrog CreatrHS (http://www.lpfrg.com/creatr-hs) using the Simplify 3D (https://www.simplify3d.com/) software.
thingiverse
The Creatr from Leapfrog (www.lpfrg.com) has a fixed idler ball bearing. I wanted to replace this by a spring loaded type to allow better control over the filament feed and allow for an easier filament change. After a few different ideas, the Mk7...