magnet for tablet 3d models
2309977 3d models found related to magnet for tablet.thingiverse
Wall mount magnet holder. ... 13mm magnet version and 16mm magnet version
thingiverse
Notes: * The "Magnet Holder" was designed to work with ball-joint style phone magnetic mounts. ... * The "GoProMount" part was designed to fit within the slot of the infotainment (no adhesion required) * Foam pads were added to print to help with grip...
thingiverse
UPDATE 11/2019 : Adding a third version with support anec with +0.5 mm thick - - - Dock for tablet with [this magnetic cable](http://s.click.aliexpress.com/e/Ldc3Xvq) and a silicon protection 3 versions : - invisible with part 2 to hide the cable...
cults3d
UPDATE 11/2019 : Adding a third version with support anec with +0.5 mm thick Dock for tablet with this magnetic cable and a silicon protection 3 versions : - invisible with part 2 to hide the cable hole - invisible with support and part 2 to hide the...
thingiverse
Replaces the infotainment system cover. ... I didn't design it to "hold" a tablet, as there aren't any ridges to keep it in place, I designed it to glue magnets on so that the tablet seems as if it was factory installed.
prusaprinters
I designed this holder to replace the “computer” that came with my Sunny Magnetic Recumbent Exercise Bike. ... It uses M3 bolts and nuts to secure in place through the original mounting holes of the exercise bike.</p>
thingiverse
A simple magnetic mount for tablets and smartphones. The inclination may be adjusted using an M3 screw and nut, and the whole base can be mounted in any plain surface with a double-sided tape, or using an M5-size screw. You will need four strong...
thingiverse
Sony Z2 Tablet magnet holder, used usb-magnet cable
cults3d
Tablet Stand - tablet holder 3D printing settings: Filename: tablet stand.STL Size mm: 99 x 173 x 100 Volume mm3: 181,423 Triangles: 18,880 Time: 7h05 website http://filestl.com
cults3d
... mm. ... layer thickness 0.1 shell thickness 1 Fill rate 30% Temperature 220C ° Corner for tablet Here is an angle for a tablet with a thickness of 5 mm and a width of 150 mm. ... Layer thickness 0.1 Shell thickness 1 Fill rate 30% Temperature 220C °
thingiverse
This here is a holder for a cylindrical magnet with a diameter of 8.05 mm and height of 4.1mm. ...Its a perfect fit so it helps to use needle nose pliers to insert.
cults3d
Wall mount for adjustable tablet designed for use with case. ...tested with 9" and 10" Tablet
thingiverse
A tablet stand for treadmills. ...I designed it for my needs, but I believe it will fit most tablets and most treadmills.
grabcad
Simple stand for attaching tablet on the table. ...Very useful when reading,
thingiverse
Just a tablet stand for a tripod. Support only the Bolt. ...Other supports no needed.
thingiverse
The neodymium magnets of a hard disk were used. ...Print Settings Printer: prusa i3 box frame Rafts: Yes ...
thingiverse
Here is tablet holder for this tablet : https://www.thingiverse.com/thing:171089 I made one parametric with a length of 200mm and 90mm large. ... See : https://www.thingiverse.com/make:466234