matchsaver 3d models

... design may work. Make sure you check the clearances on the back side of where you plan to mount the matchsaver as the 3D printed T-nuts have a much deeper profile than all-metal ones, which are designed to be low profile.

glued on the receiver of a 20ga shotgun right in front of the ejection port, used for quickly sliding an extra shell in quickly look up shotgun matchsavers to see techniques you will have to play with the placement of it to get it right for your...

The rear sight and matchsaver slide onto the picatinny rails and are secured using M2.5x5 countersunk screws. The MagExtension parts can be used to combine two magazine tubes to make an extended magazine. The coupler is a tight fit and should...