matek vtx

Matek H743 Wing Mount V1
thingiverse

Just a flat mounting surface for the Matek H743 Wing V1. You can glue this or bolt this into your aircraft. ...Then the FC sits on top of some foam tape and zipped tied down so you can move your FC from craft to craft if needed.

Matek WING flight controllers mount
thingiverse

Matek F765-WING Slider mount plate. Designed for F765 but will fit all flying wing controllers except F411-WSE. F411-WSE is much smaller. Fix bottom plate with 2 sided glue tape to your aircraft chassis and slide flight controller into it. ...You...

Matek F411 WSE Base Plate
thingiverse

A straightforward adapter plate designed specifically for the Matek FC F411-WSE, providing a simple mounting solution that fits neatly within most aircraft. The base plate features strategically positioned holes that require tapping to accommodate M2...

CATALYST MACHINEWORKS PIGTAIL + GPS MATEK
cults3d

A soft mount is required for the pigtail and Matek GPS assembly. The standoff height must be precisely set at 22 millimeters, while an offset of 27 millimeters is also necessary. ...The diameter of this critical component measures exactly 5 millimeters.

Support GPS Matek M8Q-5883
thingiverse

Here's a rewritten version of your text: Support for the Matek M8Q-5883 GPS module is available with an added RX antenna and a Crossfire antenna. ...The height of this setup is approximately 58 millimeters, while the center-to-center distance of the...

Matek ELRS Diversity 20x20 mount
thingiverse

Simple little mount for the Matek ELRS diversity receiver. The board is a push fit (depending on your printers settings and calibration) but also works if the receiver is covered by the included heat shrink using some double sided tape. ... The two...

Matek H743-WLITE 30x30 adapter
thingiverse

I have a zohd dart xl extreme wing which only has 30mm fc mounting and there where no existing adapters for this matek so i made one. Holes are for zipties. in the picture i have them running over the entire fc but later i have them running just...

Matek F405 Wing mounting bracket
thingiverse

It serves as a holder for the Matek F405 Wing flight controller. The flight controller is secured firmly to the fuselage but can be removed by turning one of the locks on either side. Two M3 x 8 mm screws are used to secure the rotating locks. To...

Matek SAM-M8Q GPS mount
prusaprinters

This is a basic mount for the Matek SAM-M8Q module, designed for one of my own frame designs but which might be a useful reference for other people working with the SAM-M8Q. ...This design uses M3 heat set inserts with a hole spacing of 29.5mm & is...

Matek F411 wing protective case
thingiverse

This is a protective enclosure designed specifically for the Matek F411-WING flight controller board. To ensure a snug fit, I carefully enlarged the internal dimensions by 0.5mm in both length and width compared to the manufacturer's specifications.

Raphax Matek Wing Rear Mount
prusaprinters

Rear equipment bay mount plate for a Matek Wing FC in a Stealthwings raphax. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 200 Infill: 100 Filament: overture PETG-Pro Grey Notes: Doesnt have to be...

Flynoceros Sköll v3 Specialist - Matek GPS Mount
thingiverse

Matek GPS Mount For Flynoceros Sköll V3 Specialists. ...This mount is specifically designed to accommodate antennas on the VTX, which should be installed at the front of the aircraft.