metal chassis 3d models
152332 3d models found related to metal chassis.grabcad
A 6wd chassis with a dropped center wheel. 2 omni wheels that drag along the ground for positional feedback. It is powered using two, 3 CIM gearboxes made based on the WCP 3 CIM gearboxes. ...This was built in our pre season and although we ran out of...
prusaprinters
Just a simple set of mounts designed to fit underneath my PrintrBot Simple Metal, to allow fans to be mounted to cool the Z/X motors and stepper drivers on the main-board. UPDATE 09/01/2015: I found that the friction fit was a bit too ambitious, and...
thingiverse
Instructions This mounts are designed to sit the fans within the chassis, but only at an 8mm depth - this is deliberate to give more space between the motors and the fan to maximize airflow, and also to allow as much clearance as possible for the...
youmagine
I have some low profile fans (only 10mm depth on a 60mm fan) on order, and they will sit more or less flush with the bottom of the printer once fitted.The ones shown in the pictures are standard 60mm fans, and have an overall depth of 19.5mm, so...
grabcad
STEM Capstone project to practice designing and building with sheet metal in FIRST Robotics application
thingiverse
Use 15x10x4mm ball bearing Use motor with 0.75x3.5mm spindle Need two part. Fit on motor spindle. Need good fit. Difficult install done to. Need best skills. ...Not for new person
grabcad
This Chassis is made from sheet metal and can be configured for 6 and 8 whee drive systems with different gear boxes.
thingiverse
A chassis base for small robots, able to fit most arduino boards and similar and it's designed to fit Micro Metal Gearmotors and Encoders. Instructions The dimensions of the chassis are: 122x109.68x1.2mm Depending on the slicer configuration, the...
grabcad
A sheet metal chassis chassis, including heat sinks, ventilation holes.