▷ miata keyring 3d models 【 STLFinder 】

Miata MX-5 Popups Keyring by BEAVIS
thingiverse

Miata MX-5 MX5 Mazda Popups Keyring by BEAVIS

MX-5 logo emblem keychain keyring - Mazda Miata Roadster NA NB
cults3d

I have a Mazda MX-5, so I made a keyring for its keys. It could be nice with any color, but I only tried it in black. ...It is easy to print.

2D Miata
thingiverse

2 Dimensional Miata

MIATA Hardtop
grabcad

NA MIATA Hardtop

Mazda Miata
cults3d

Mazda Miata MX5 tuning modification

Miata Keychain
thingiverse

Just a little keychain i made for my miata.

Miata Logo
thingiverse

Miata Logo I created using Fusion 360 for my Miata. Prints in one go as everything is connected. ...Ideal for gifts, car badges and more!

Miata Keyholder
thingiverse

Remixed CO-OCD NA Miata keychain as a keyholder Printed at 0.2mm, with supports and 30% infill

Miata Logo
thingiverse

Made in SketchUp Make for a friend with a Miata. I tried to get it as close to the original as possible. ... Scale, use and print as you see fit.

Drift miata
pinshape

Summary This is a samll miata mx-5 that i have made. its a pretty complex model i dont know how the result will end up but thats the fun? ...My youtube page: https://www.youtube.com/channel/UC6mvenBzMvfVgJbc0S5EaTA

Miata keychain
thingiverse

A simple keychain of a NA mx-5 miata I made. I used a 0.20mm layer hight with 20% infill, using hatchbox pla and had good results. ...Hope you enjoy!

Shiftknob Miata
thingiverse

Hey, I wanted to swap my shiftknob in my Miata, so i quickly designed one with the proper holes and thread (M10x1.25) to screw it on. ...I added the old mazda logo, but if you want i can upload one without it.

Drift miata
thingiverse

This is a small miata mx-5 that i have made. Its a pretty complex model i dont know how the result will end up but thats the fun? ...My youtube page: https://www.youtube.com/channel/UC6mvenBzMvfVgJbc0S5EaTA http://maksim0238.weebly.com/

Miata Cupholder
thingiverse

This fits into the panel holes on a gutted 1991 Mazda Miata. I assume all the panels have these holes. Only works if you don't have carpet. ... The print required a tiny amount of sanding for me so I bumped the pin width down 1mm for each but I...

Miata Keychain
thingiverse

I just added a base plate, a hole to put it on a keyring, and beveled the edges. Use a low infill, as the part is just cosmetic. For best results, print with the thinnest layer height. The uploaded dimensions are about 105mm (4 inches) by 32mm...