micromark 3d models

I've owned this Modular Work Holder from Micromark Tools for quite some time now, and it's been a valuable asset in my workshop, allowing me to hold small parts securely while working on various projects. However, when I wasn't using the holder and...

I needed to bevel the edge of a piece of wood to a precise 45-degree angle, so I came up with this design to work seamlessly with my trusty micromark sand-it. To get the job done right, I included three different versions for added flexibility.

I modelled this part at the exact dimensions taken from the original part (mine was cracked). On my printer, the inside diameter was a bit too small at 0.55mm undersized. The slot for the support arm was likewise too small. Depending on your...

Taper rip sled for model making table saws like Proxxon and Micromark. Safely holds small parts for cutting. Uses the saw's existing fence.Thanks Gabcad and Aidan McMaster for the 6mm Bolt Head Knob. ...Model is in millimetres.

... For the required springs, check out Micro-Mark's 101-piece assortment at http://www.micromark.com/101-piece-spring-assortment,7839.html and watch this YouTube tutorial for guidance: https://www.youtube.com/watch?v=urX5DbJPRu8.

I just purchased this set of 8 sanding sticks for my scale model and printed item finishing work from https://www.micromark.com/Softback-Polishing-Sticks (and honestly, if you can find them somewhere else, I'd buy them there. ... They took forever to...

When making pens, its necesary to glue a metal tube into a piece of material so that it can be turned on a lathe.  Often this uses instant glue.  Since instant glue will not stick to silicone rubbver, a silicone rubber plug can be used to prevent...

I used tiny screws from a sunglasses repair kit (Micromark's Micro Screw Assortment Item #83438) to secure the clamp - two of them work perfectly: one keeps the clamp over the air hose and the other holds it tight. ...To keep everything in place, I...

... precise cutting applications. For those interested in exploring this project further, I have included a link to the MicroLux jigsaw, which can be accessed through the following URL: https://www.micromark.com/Micro-Make-MicroLux-Jigsaw-Scroll-Saw

This handle is for use with miniature carving chisels like these from Micro-Mark: https://www.micromark.com/Miniature-Chisels-Set-Of-7 I found I wasn't using these chisels as much as I wanted to because of how hard it was to get a good grip on such a...

I used 2x tiny screws from a sunglasses repair kit (Micro Screw Assortment (Item #: 83438 at Micromark), adding one allows the clamp to be placed over the airhose and the second one secures it. ...I added an 8" zip tie to hold the two halves closed, as...

I prefer Same Stuff. Depending on your print tolerances, it may be necessary to add a small amount of glue to hold the threaded connector bushing (dia. 22 mm x 7 mm) from the tBulb in place. Run the power cable through the hole in the back of the...

These fabulous sticks are available at micromark.com and i'm just completely tickled with them for working on flat items with this jig. They're great for non flat items when not in the jig. This is designed to sit on top of a tile. The ledge...

Using one-to-one mix silicone rubber (available at Micromark) and a 10 ml syringe (without the needle), the holes on the top can be used as fill and vent holes. Allowing bubbles to rise in the syringe before injecting the mold, covering the inside...