minnowboard turbot 3d models

I remixed this case to fit a MinnowBoard Turbot Dual Ethernet. I fixed the location of the holes a bit. This should fit now. Added a lid version with hole for heatsink (e.g.

A colleague I'd printed these for found the top and bottom surfaces a little flimsy and asked that I make them thicker. While I was at it, I removed all of the excess hex holes because of the amount of print time added for all of the perimeters.

I liked this slimline case but I have the Turbot B Minnow Board that comes with a large heat sink. I initially thought about just about bringing the lid height up a few millimetres, but thought it would be better for cooling and airflow if the heat...

A lid designed to go onto the Minnowboard half-case: http://www.thingiverse.com/thing:389100

This is the "official" MinnowBoard MAX half case, done by John "Warthog9" Hawley and the git repo for it can be found at https://github.com/warthog9/minnowboardmax-case Keep in mind this has been calibrated for a Formlabs Form 1, though has been test...

===================================================================== Fork of the Minnowboard Case by RomHartman... Some improvements Slimer Access to all the pins Fixed the screw holes position Fixed height of SATA port. Fixed position for SD card...

Comes in two simple halves.

No description provided.

Custom minnowboard max case that houses several things: minnowboard 2.5 in SSD drive battery holder fan extra holes for specific stuff. Instructions The holes are sized for 3 mm hex screws. Test...