nalgene carboy 3d models
346 3d models found related to nalgene carboy.grabcad
Nalgene lab carboy 20l GL80 with or without cap. ...In the SW-model, the cap can be made visible with a configuration.
grabcad
A carboy cart idea which can lift and transport the carboy. ...Some parts are made by peers.
thingiverse
A cap to turn a carboy into a change jar. ... It snaps onto the carboy but isn't a tight fit.
thingiverse
I modified the original carboy wedge adding round extrusions inside the part to help support the weight of a full carboy.
thingiverse
This is a locking top for a 6.5 gallon carboy with a coin slot. ...The pad lock is a small brass lock from Ace Hardware, but any similar lock will work. The carboy is a 6.5 gallon, but I believe the the 5 and 6 gallon carboys have the same size neck.
thingiverse
A wedge for propping up the edge of a carboy to facilitate racking beer or wine. The wedge has three height settings. ...For better support, use two wedges.
thingiverse
The scad file is attached, which allows easy editing of diameters, heights, angle of carboy glass where stand supports it, number of "legs", ratio of legs to holes, etc. ... Note that at full resolution, it takes ~10 minutes to perform a final render...
prusaprinters
The neck of the carboy is held in place so that it cannot tip while in the stand. The design is made using two bezier curves, extruded rotationally, and then rounded holes punched in the sidewall for airflow and less material usage. The scad file is...
thingiverse
Picked up some PET carboys (Better Bottle, etc) and discovered that the carboy nozzle base on my Fermtech Double Blast was just a bit smaller than the opening diameter, making cleaning somewhat awkward. ...This adapter slips on (tightly) and provides...
thingiverse
The purpose of this is to prevent oneself from spilling while drinking from a wide mouthed Nalgene water bottle. ... Instructions Just stick it in the mouth of a Nalgene water bottle.
prusaprinters
Picked up some PET carboys (Better Bottle, etc) and discovered that the carboy nozzle base on my Fermtech Double Blast was just a bit smaller than the opening diameter, making cleaning somewhat awkward. ...This adapter slips on (tightly) and provides...
thingiverse
I wanted an outdoor cupholder that could be fit everything from a Nalgene to a coffee cup.
thingiverse
This is a spout so that you don't spill when you take a sip out of your nalgene brand water bottle.
thingiverse
Simply place this stopper into the top of your Nalgene and enjoy the convenience of a smaller opening to drink from on the move. EDIT: The original design would get wedged very tightly (to the point of not being able to remove it) so I made the new...
thingiverse
(Well, not all of them...) I designed this super simple coaster to be more or less molded to the underside of a standard Nalgene bottle. It fits fairly nicely, keeps the bottle centered, and helps resist knocking it over at least a little (I am not...
grabcad
Transport cart designed for Biolife company to help improve safety and efficiency. ...Carboy model and Carboy holding arm models designed by Rosie Belmont.