nokia 5510 3d models
2595 3d models found related to nokia 5510.thingiverse
Round enclosure that I made for my arduino project, using Nokia 5510 LCD. You need to use hot glue at the corners on the lcd for fixation. Lid is not tight fit, also use silicon etc. for fixation. ...
thingiverse
The tiny cousin to https://www.thingiverse.com/thing:3854354 Designed for screwless/glueless friction fit. Make sure your printer XY compensation is properly calibrated. ...Opening on the side is untested and might not fit properly.
cgtrader
A 3D model nokia 5510 phone made in blender 2.83 and its textured not in on piece but in pieces. it has lights in its project file (blender) and it is exported three different formats those are; obj.dae and fbx. ...
thingiverse
Made for a datalogger project based on a few i2c components, an Arduino Nano clone and a Nokia 5510/3310 type display. Might look quite ugly but it is very easy to print. Update: parts now contain a partial bezel to hide the PCB - It stuck out quite...
prusaprinters
Reverse engineered HP Photosmart 5510 paper holder/bracket.
thingiverse
... ... The CM 5510 drip tray is a little different than the CM 6*. While the original worked, it was a bit of a tight fit. I made the base a little shorter and changed the back so that the stepped section starts at the base and goes all the way up. ...
thingiverse
This is a small bracket needed to mount an M.2 SSD in a Dell Latitude 5510.One small screw holds the bracket in place, and a second holds the SSD to the bracket.
cults3d
Essential accessory to raise your laptop enough to provide maximum cooling reducing thermal throttling therefore potentially increasing performance! ... Designed for a Dell Inspiron 5510 15.6", it may also work with other Dell laptops