octopus tablet stand 3d models
164075 3d models found related to octopus tablet stand.prusaprinters
Here's another go at the Octopus stand. I know some people had issues with previous version with weighty tablets falling off. This should hopefully alleviate those problems. ...Happy printing! Intended scale: 210mm x 132mm x 69mm (approximately) Note...
cults3d
Here's another go at the Octopus stand. I know some people had issues with previous version with weighty tablets falling off. This should hopefully alleviate those problems. Happy printing! ... Intended scale: 210mm x 132mm x 69mm (approximately) ...
thingiverse
Here's another go at the Octopus stand. I know some people had issues with previous version with weighty tablets falling off. This should hopefully alleviate those problems. Happy printing! ... Intended scale: 210mm x 132mm x 69mm (approximately) ...
thingiverse
I used Blender to pull the front tentacles a bit to accommodate a tablet in a case.
thingiverse
This is a tablet stand that has a raiser for the cord to plug into the bottom of the tablet. ... Print Settings Printer: Duplicator i3 Rafts: ...
cults3d
One more octopus arm thingy. This one holds up your tablet or phone! Should fit an iPhone 4/5 in portrait or landscape no problem. ... Intended scale: 118mm x 114mm x 88 mm (approximately) Note this is just an experimental model, I have not...
thingiverse
One more octopus arm thingy. This one holds up your tablet or phone! Should fit an iPhone 4/5 in portrait or landscape no problem. Intended scale: 118mm x 114mm x 88 mm (approximately) Note this is just an experimental model, I have not printed...
thingiverse
Let's try this again! ...My previous remix wouldn't allow for the correct file to be updated. I liked the original but my tablet and phone kept sliding so I added cuts to the arms to keep it stationary!
prusaprinters
... holder tentacles. ... I would recommend 0.2mm layer height and like 5 perimeter walls. I did try standing a laptop on the model, closed was fine but open started sounding crunchy. The blender file is also attached but has some issues.
prusaprinters
Version three of the Octopus tablet stand. This one was designed to fit the iPhone 6/6 Plus, iPad Air and a slew of Android devices. There should be just enough room for a case with most devices. I recommend adding a little bit of sticky adhesive to...
cults3d
Version three of the Octopus tablet stand. This one was designed to fit the iPhone 6/6 Plus, iPad Air and a slew of Android devices. There should be just enough room for a case with most devices. I recommend adding a little bit of sticky adhesive...
thingiverse
Version three of the Octopus tablet stand. This one was designed to fit the iPhone 6/6 Plus, iPad Air and a slew of Android devices. There should be just enough room for a case with most devices. I recommend adding a little bit of sticky adhesive...