one tbs 3d models
549079 3d models found related to one tbs.thingiverse
Source One TBS Unify VTX mount. ... Still in development, testing PETG and FLEX printing.
thingiverse
I noticed the Source One V4 locked down a ~20mm camera pretty tightly so I designed replacement camera plates for printing. ... Edit: 2-2 Added a 20mm variant by request
thingiverse
This is the upgraded version of the popular TBS Unify PRO32 HV holder for the Triumph Pro antenna. Weight is reduced by 30%, this design weights only about 3.5 grams and is very strong. ... Enjoy!
thingiverse
I am using a modular Session mount at a 25 degree angle, and you can get the GoPro portion here: https://www.thingiverse.com/thing:4580640 The front mount holds a mini immortal T, and uses the extended one TBS sells, while the back uses a regular...
grabcad
TBS SOURCE ONE V3 frame, with 5inch, 7inch and 7inch dead-cat size of arms.
thingiverse
A couple accessories for the TBS Source One frame. ...Should work with all versions.
thingiverse
This is an Antenna holder for the TBS Source One V5 5inch Frame with the Walksnail Antennas.
thingiverse
Some parts to hold a runcam micro, the reciever, XT60, GPS and VTX antenna on my TBS Source One
thingiverse
VTX + Antenna Mount for TBS Source One v0.3 and v0.2 +Standoff min 20mm +Lollipop Stubby or normaly
thingiverse
TBS Source One V5 5-Inch Frame Required Hardware: 16X M3x10 Allen screw 4X M3x12 Allen screw 4X M3x14 Allen screw 4X OD 5mm M3 30mm standoff 4X OD 5mm M3 22mm standoff 8x M3 press insert nut
thingiverse
TBS Source One frame. Since the files were open source I figured why not. Print 2 camera mounts and 4 arms. Pick between M3 holes or press nut holes on the arm plate. https://youtu.be/8qjpnIgd-O4 https://youtu.be/oWpCZgJzntc 9/30/2018 - I...
cults3d
Tail for TBS Source One, print in TPU 75% infill. ... Mount for SMA pigtail + Vertical Crossfire mount + LED strip Print 2 of immortal_t.stl and mount as pictured using regular rx antenna tubes like these...
thingiverse
Tail for TBS Source One, print in TPU 75% infill. ... Mount for SMA pigtail + Vertical Crossfire mount + LED strip Print 2 of immortal_t.stl and mount as pictured using regular rx antenna tubes like these...
thingiverse
I created this for the TBS SourceOne to hold my XT60 connector, antenna and receiver. I printed it with PLA using 30% infill and no supports. ... ( FYI when printing rotate it 90 degrees to sit flat like it would be in the frame.)
thingiverse
- ND filter session mount - Front bumper - Arm guards - Antenna mounts - Micro cam mount Prints are available for purchase here: https://bmc3d.co/collections/all/source-one
thingiverse
It's my own contribution for the TBS sma mount on the TBS Source ONE project
thingiverse
TBS Source One SMA Antenna mount Print in TPU https://www.tinkercad.com/things/hwBa2waeGs1-tbs-source-one-antenna-mount/edit