optical flow sensor 3d models
65196 3d models found related to optical flow sensor.
thingiverse
This is a quick mount I drew up for the Mateksys Optical Flow Sensor. ...Fits at the rear of the Speedybee 5 HD V1 nicely.
thingiverse
... direction. The description of the sensor is here: http://store.3drobotics.com/products/optical-flow-sensor Instructions Should build easily. ...The two case halves fit and stay together, but this depends on the quality and accuracy of the print.
thingiverse
Optical Flow Sensor ADNS 3080 for use on F450 frame
thingiverse
I wanted to implement the Matek Optical Flow (LIDAR) sensor on this frame, as it has a specific mounting area for it with appropriate screw holes and apertures for the two sensors on the board. When attempting to attach it with a set of 3x12 hex...
thingiverse
Here are two versions: - wires aside - wires up
grabcad
This is a quick design for a optical flow sensor mount for the Aruducopter/Ardupilot platform. ...It is designed to be mounted on a Arducopter 3DR set up in the X configuration.
thingiverse
Enclosure for Cheerson CX-OF Optical Flow sensor. Sensor can be used to improve horizontal position control especially in GPS denied environments. ...
grabcad
Optical sensor with a slot of 3mm. ...A sensors that include an infrared emitter and phototransistor,located face-to-face on the optical axes.
grabcad
The optical-flow module is enabled by a STM32F407 with OV9655 camera. The height is compensated with an ultrasonic sensor or a infrared sensor. The estimated velocity has an error of 0.02m/s. ...And with the sensor, position estimation will have drift.
thingiverse
The case for TO-8 optical sensors e.g. (https://www.hamamatsu.com/us/en/product/category/3100/4001/4103/S1226-8BQ/index.html) with the BNC connector. In my case, I have used BNC for a panel ...
myminifactory
I designed this project as a solution to the ineffective, inacurate, and costly probes out in the market today. My project uses a LM393 Dual Differential Comparator IC and will output in Digital and/or Analog This type of sensor can detect distance...
grabcad
MicroMotion Flow sensor model F300H - 3" hastellow. ... Same as F300S - 3" stainless
grabcad
SITRANS FM MAG 1100 F Full-Bore electromagnetic flow sensor sanitary design diameter DN 10 to DN
thingiverse
Flow Sensor Components (See Figure 22 in Pompano Manual) should be printed in PETG (preferable) or PLA with at least 20% infill. Use supports such as "Tree" supports found in the CURA slicer. Use 3-4 layer lines for walls, 4 is better if the hole in...