pettigrew wand 3d models
4489 3d models found related to pettigrew wand.cults3d
This is my Peter Pettigrew Wand design. Inspired from Harry Potter! This model made by me! Modelling time 3 hours! It is a high-resolution model. NO SUPPORT! JUST PRINT! WITHOUT SPLIT (FULL) WAND IS INCLUDED! I hope you like guys! If you have any...
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/3vBe7ULZo8m
cults3d
260 mm Peter Pettigrew Wand Length approx. 235 mm Ron Weasley - first Wand Length approx. 305 mm But you can scale the model according to your needs If you’d like to suggest what we should do next, check out our pre-order page and fill in your...
sketchfab
This limestone(?) bust of an unknown female is in the rear annex of the Pettigrew Home & Museum. It was purchased by Senator Pettigrew during a trip to Egypt. It is on the lowest shelf of a display case with highly reflective glass. Hence I could...
sketchfab
A model of a wand, this wand has a cylinder body featuring a pointed tip, the lower part has larger cylinder bands to the wand and an orb based.
prusaprinters
... a modular wand. ...the base has a thread and there is a screw that you can attach to the wand portion so it can screw in. you can always just change the wand from the handle.I am only including the one wand, but added the 3mf file so you can make more!
sketchfab
Simple wand, modeled using procedural Voronoi texturing. ...Rendered in Cycles at 1.000 Samples.
myminifactory
... twenty-seven human faces in relief, each with a different expression. ...The wand was made by Eskimo tribes and discovered in Abverdjar, Canada ______________ This object is scanned by the Museum of Archaeology and Anthropology, Cambridge, England.
thingiverse
This magic wand will take care of it. In fact, it will resolve all of your issues. With a swing of your hand and recital of a magical phrase, this will make you stress-free and problem-free! Do not worry, this device will not drill a hole in your...
thingiverse
A 3D star wand. Instructions I used a 1/4" fiberglass rod from an old flag that goes on a kid's bicycle. I cleaned out the hole with slightly larger "lettered" drill bits until the rod fit snug...