pltw cube 3d models

Tools used:-polygon-boss extrude-Mass = 27.00 grams-Volume = 27000.43 cubic millimeters-Surface area = 5400.06 square millimeters

I sketched on a front plane, using a polygon tool, 4 sides and 50mm edges. Then, I created an offset plane and sketched the same polygon. ...And finally, I used a loft, 50mm tall.

I made a rectangle with equal sides and then extruded the base to the length of the side.

6 sided figure

drew a square and extruded it

For 2D I used the line tool.For 3D I used the extrusion feature.

I started with the Top Pane. I made a square with lines then smart dimensioned them 10mm. I then clicked on featured and extrude boss/base. ...I clicked on the dimension and changed it to 10mm.Mass: 1.00 gramsVolume: 1000.00 cubic millimetersSurface...

go to the video for a step-by-step creation

Modelled in Catia

I'm thrilled to submit my innovative design for the Vectary Design Competition, proudly supported by MakeX. This striking model was carefully crafted using VECTARY - a cutting-edge, free online 3D modeling platform that empowers creativity. ... Special...

Fleshly Formations Require Precise Layering At 0.3 Millimeter Increments With Infill Patterns Achieving A Density Of Ten Percent.

BLENDER

People often use a small, three-dimensional model made from interlocking plastic parts that measure exactly 3 centimeters in both width and height to showcase a basic concept of size and shape. Instructions Firstly, find a high-tech device capable...

Modelled from scratch in Sketchup 2014, the design was then tweaked to perfection in C4D before being polished off with stunning Vray rendering techniques. ...All materials and lighting effects are carefully crafted and applied, ensuring a visually...

Software : BlenderRender : Cycles

Printing begins at a precision of 0.2 millimeter per layer, with 90% solidification throughout the material. ...This process consumes 23 grams of filament and is expected to take approximately three hours and thirty minutes.

I used the polygon tool to make a square then used the extrude boss/base tool to make it into a cubeMass = 467.20 gramsVolume = 64000.00 cubic millimetersSurface area = 9600.00 square millimeters

2d tools used were just center rectangle then for 3D tool I used the extrude base.

For this model I created a centered square using the polygon tool. ...Then, I extruded it.Volume: 10mm x 10mm x 10mmMass = 1.00 gramsVolume = 1000.00 cubic millimetersSurface area = 600.00 square millimeters

A typical sketch most of us create-let's hope it benefits someone. Free to utilize or adjust without limitations. ...Designed using Solidworks 2014 software.

An uncompleted art project emerged from a creative concept I once had.

Customized version of https://www.thingiverse.com/thing:1672381 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1672381