pole model
2064792 3d models found related to pole model.
thingiverse
The old flag that was attached to the pole had an open sleeve on the left that the pole slides into, and was secured in position with hot glue. The replacement flag she bought has two eyelets on the left, one at the top, and one at the bottom. I...
thingiverse
... design, I duplicate it and pasted. ...I will use this to screw a wifi router to a paint pole that we are using as antenna pole. ... So the router will be zip tie to this piece and I can screw the router to the pole and take it out after use
thingiverse
The cylindrical component slides down over the pole and comes to rest about 1.2 meters above ground level (on Haverford's heavy-duty squid poles). ...Three anchor points are spaced evenly apart at 120-degree intervals, supporting three radial guy ropes.
myminifactory
Read Telegraph_Pole.txt file. The model can be configured in many variants.
grabcad
FreeCAD model of a flag pole mount based on the referenced YouTube tutorial.
thingiverse
I had printed the adaptor in PLA, carefully designing it not to clip too tightly around the pole, thus preventing excessive stress on the material. ...Ideally, I would have used Nylon instead, allowing the adaptor to cup further around the pole and...
thingiverse
Its not pretty, I'm not a designer by trade but it works to add a pole extension to your existing monitor pole for a light monitor. (I would NOT use a full sized monitor with this as I don't trust the PLA will hold the weight. I'm using a super...
thingiverse
I designed this OpenSCAD model to allow wildlife camera mounts on the same pole as bird feeders. It also adjusts the horizontal pole's angle based on requests. The parameters include clamp height, screw hole diameters, and pole diameters for precise...
thingiverse
... in question is where the elastic cord attaches, linking the other poles together securely. Specifically, it's designed for a pole with an inside diameter of roughly 1/4 inch. The model that fits snugly into this pole measures .28 inches in diameter.
prusaprinters
If you lose the pole cap or build your own pole from some old pipe, you can use this cap.The legs are designed to be slightly bendable so that they can fit poles with different wall thicknesses.The outer diameter for the pole should be easily matched...
thingiverse
Check out this little ski pole hanger I came up with - it's perfect for holding two sets of ski poles or trekking poles in place. There are two versions available, one that can be stuck onto the wall using command hook-style strips and another that...