polycaster 3d models
7 3d models found related to polycaster.thingiverse
The Polycaster is a design I've been working on for a while and finally decided to print it. The main body is made up of 6 pieces that I've epoxied together. The main middle part was printed with 100% infill and uses almost an entire roll of...
thingiverse
A wedding ring I designed. ...Comfort fit with a little wavy grove on the outside. Size 7.5 approximately. Made with the Polycast last Pla filament for investment casting. ...Then made a silver ring with it.
thingiverse
I printed this polycast (polysmooth) and smoothed it using IPA Post-Printing Poly smooth Mine was printed in polysmooth. I put it in an inflated ziplock bag with rubbing alcohol and shook it for about 10 minutes to smooth it out. ...you could do the...
grabcad
... it is a Crown Vic, but I'm not sure. I don't have a picture of the finished part unfortunately. I printed the switches in polycarbonate, sanded and spray-chromed. Also made a mold with Polymaker Polycast and cast a few switches in bismuth/tin.
thingiverse
Fusion source included if you need to tweak, but it was a quick design, so may not be pretty :) No-Dig Fencing Stakes: https://www.homedepot.com/p/Hampton-Bay-Empire-Westbrook-3-in-x-2-3-in-W-x-3-4-ft-H-Black-Steel-Fence-Post-860237/205371763 Cheap...
grabcad
I use regular plaster of paris with some fine sand for the mold and the negative is printed in either PLA or Polymaker Polycast. No supports needed. Melt out the plastic, burn out any remnants, drop in your lead then chuck it in a bucket of water...
thingiverse
I decided to do this as sort of an A/B test from my previous 3D printed guitar, the Polycaster (which I have now consistently had .10 gauge strings on it). I plan to see how much the body warps under the lighter gauge strings so I'll know if I will...