proform hiit tablet holder 3d models

Needed a tablet shelf for our Pro form HIIT trainer. They make one but it is hard to find anywhere so I designed my own. ... Added a couple of photos of it installed.

... close to the panel so lager tablets could fit. The original plan was one wide piece but two smaller ones seem to work better. I suspect other Proform and Nordic-track treadmills use the same tablet holder so this might work for other devices. ...

The stock Pro-Form Carbon CX tablet holder is too narrow to hold any tablet with a case on it. I designed this one to be sturdy, and to hold nearly any size tablet. I have printed this and it works great. ...There is a left and right side.

The ProForm 580 treadmill does not have a tablet holder, this is a solution and does not block the cooling fan. It was made for 7" to 8" tablets, but would probably work with a 10" tablet in a pinch. There are numerous reinforcing ribs on the...

The tablet holder that comes installed on the Pro-Form Carbon CX bike is not wide enough to hold any tablet with a case on it. I made this sturdy 2-piece replacement to hold just about any tablet. I've been using it for a couple weeks and it works...

The tablet holder that comes installed on the Pro-Form Carbon CX bike is not wide enough to hold any tablet with a case on it. I made this sturdy 2-piece replacement to hold just about any tablet. I've been using it for a couple weeks and it works...

tablet support

High-quality, photorealistic and accurate 3D model of Stairmaster HIIT Bike. The 3D model was created on real Stairmaster HIIT Bike base. ...It's created accurately and in real units (cm).

Tablet holder

tablet holder

Simple low profile tablet/phone holder for devices that are 7-10mm thick

tablet holder 111x104x7 mm

tablet holder p

bedstead holder tablet

Tablet or mobile holder

lcd, book, tablet holder

its a Tablet Holder

Holder for tablets.

Simple low profile tablet/phone holder for devices that are 7-10mm thick Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: 0.2mm Infill: 25% Category: Gadgets

Tablet Holder edprinting and wood.

a Tablet holder while charging

Tablet_Holder_For_3d_printer

Simple, good-looking tablet holder! ...:)

Simple tablet holder. ... Holds tablet vertically or horizontally.

tablet holder up to 1 cm thick

Simple Tablet holder for 3d print

Here are a tablet holder I just made for a Denver 10" tablet.

Just a tablet holder for use with iZettle

this is a tablet holder for ARNOVA 10G2

This is an easy print for a tablet holder....enjoy