protractor automotive software 3d models
108157 3d models found related to protractor automotive software.myminifactory
This is a protractor for different uses e.g. ...for indicating the angle at cannons
thingiverse
Custom made protractor very handy tool for geometry, math and other projects.
thingiverse
A simple protractor for measuring angles. ... The SCAD file can be used to produce a tool with customized numbering and tick mark intervals.
grabcad
We had problems in measuring the angle between walls of a cabin from interior. ...Then I designed and made this particular protractor from Plexiglass. ...It also has a useful table for sines and cosines.
thingiverse
This is a protractor ============== It is possible to use the reference with the needle on the notch or with the number in the circle. The ring nut is threaded to tighten and lock the rod. It can measure from 0 to 180 °, and is symmetrical. ... It...
thingiverse
This is a protractor with degree markings. Because there are no distance markings, you can scale it safely. I made a square as well. ...http://www.thingiverse.com/thing:1753198 Print Settings Printer: Flux 3d delta ...
thingiverse
Explanation : The protractor was modeled in 3D. A bolt of M8 standard was put in the center of the protractor. M8 nuts can be used for coupling. M8 butterfly nut is included in the modeling file, so you can print it out and use it. You can also...
thingiverse
A six inch protractor. Will be accurate if your printer is accurate. To measure angles, align the inside straight edge with the bottom side of the angle, with vertex at center line of the rule.. Angles are marked every 10 degrees with 45 degrees...
thingiverse
A protractor. 120mm diameter. The outer ring is graduated every 7.5degrees. The inner ring is every 10degrees. I know this is a little odd but this is what I needed for a project. There is a vertical fin which is very useful for aligning with a...
grabcad
It is an Automotive Part developed on CollabCAD. ...I have shared STEP file with you.