ptr c93 3d models
256 3d models found related to ptr c93.thingiverse
If you would like to buy a print of this with metal inserts in the drill holes, please check out my gunbroker page: https://www.gunbroker.com/item/858377600 This is version 1.2 of the C93 paddle release jig I previously released. this version...
grabcad
PI-EXP project:PTR_AKZ950_5F_508_HC and PTR_STLZ950_5F_508_V connector
thingiverse
I was finding which calibre PTR buy but i wasn't sure which calibre buy, so for see the real size i made this PTR of 1inch x 1inch
thingiverse
Replacement case for the u-blox C93-M8E GPS receiver, designed because the original case deformed in heat. ... My first design; it probably would make sense to round the corners.
prusaprinters
Replacement case for the u-blox C93-M8E GPS receiver, designed because the original case deformed in heat. My first design; it probably would make sense to round the corners. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No...
thingiverse
Customized version of http://www.thingiverse.com/thing:175150 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=175150 Instructions Using the following options:...
thingiverse
Customized version of http://www.thingiverse.com/thing:175150 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=175150 Instructions Using the following options: line_10...
thingiverse
Just a cover for the top an 1.5" tubular PTR It is on inches, you have to upscale 2450% to get correct measures in Cura
thingiverse
Note this is my final version (v4) of this design. It has rounded edges at the top to avoid catching the spring edges upon compression. It is also cut out at the bottom to fit around the spring on the baseplate. Note, you should print this on its...
thingiverse
The gas port on KWA airsoft magazines is exposed. ...I designed this to cover the gas port and provide some drop protection to the magazines. It fits the LM4 PTR Series 40 round magazine.
thingiverse
Hardshell magazine holder for HK-G3/HK-91/PTR-91/CETME rifle magazines. ...Only for .308/ 7.62x51 variants Might be useful, might not, just figured I'd finally design one for the public since it doesn't seem like there are too many options out there.
thingiverse
This is a sight alignment tool for welding your HK drum sight to your HK roller-delay series receiver, or CETME C receiver. To use the tool you simply clamp it in place with the drum sight loosely placed on top of the receiver. Align the sight tool...
grabcad
PTR rack used to support cheking fixtures in warehouse.
sketchfab
https://www.nitori-net.jp/store/ja/ec/CarpetRugMat/FloorMatEntranceDoor/8250214s?ptr=item
sketchfab
https://www.nitori-net.jp/store/ja/ec/CarpetRugMat/FloorMatEntranceDoor/5633417s?ptr=item
sketchfab
https://www.nitori-net.jp/store/ja/ec/InteriorLifeGoods/WallInterior/8142517s?ptr=item