pvc venturi tee 3d models
15109 3d models found related to pvc venturi tee.thingiverse
My first attempt on printing a venturi for small solar power fish pond pump. Works well. ...Installed about 30mm from water surface.
grabcad
Standard PVC Tee connection. Size 2". Measured from real part. ...Thought someone could find it usefull
grabcad
Configurable pvc tee fitting. ...3/8", 1/2", 3/4", 1", 1.25", 1.5", 2" 2.5",3", 4", 5", 6", 8", 10", 12"
thingiverse
I made it so that I could put a tee on a length of pipe without cutting the pipe. We used it to make a canopy, with both ends of the pipe supported, so it didn't need to be very strong. Be careful not to overtighten the hardware, but otherwise...
grabcad
one side is the measurement of a 1 1/4 pvc pipe while the other three are 1 inch pvc pipe
thingiverse
Snap on T connector for Vivosun grow tent pole (16mm) to add additional cross bar using 3/4" PVC. ...
cgtrader
Standard PVC Tee connection. Size 2". Measured from real part. ...Thought someone could find it usefull
thingiverse
This is an aerator I designed for use in my aquaponics fish tank. ...The openings are for 1/2'' pvc pipe and it is meant to be mounted vertically, it may still work at an angle or horizontal but I haven't tested it in those scenarios.
grabcad
Right-angled PVC Fitting based on PN-EN 1852. ...Angle changed from original 87,5 to 90,0 due to assembly conditions.
grabcad
All credits go to Filip Kober and his 3D project 160mm PVC Pipe Fitting Tee - I just made some adjustments