raspberry pi case solidworks 3d models

304771 3d models found related to raspberry pi case solidworks.

Raspberry Pi zero case
thingiverse

I designed only the top of this case, borrowing from another project that's linked in the source files. I couldn't find a suitable top with ventilation holes and cutouts for 40 GPIO pins, as well as the four adjacent pins (composite video and reset...

Raspberry Pi 4 case
thingiverse

I modified case for 36 mm fan, no overheating after overclocking to 2,15 GHz. For more info see original model: https://www.thingiverse.com/thing:3723481 If you like this model, feel free to live a donation, so I can make more models. Every...

Raspberry PI 4b Case
thingiverse

The radii around the top and bottom of the case ended up looking like chamfers on my print. You may want to use supports on yours. Also, the chamfers around the mesh holes didn't turn out as well. I modified the recesses for the 2 micro HDMI and...

Raspberry Pi 4 Case
thingiverse

casing bottom || additionally required: 4x knurled nut M3x5 4x screw M3x5 The knurled nuts (M3x5) are pressed into the provided holes on the outside of the housing with a hot soldering iron. Thereby the top of the case can be screwed to the bottom...

Raspberry Pi Case Stackable
thingiverse

Check out these case options on Thingiverse: [link 1](https://www.thingiverse.com/thing:2808762), [link 2](https://www.thingiverse.com/thing:682673), [link 3](https://www.thingiverse.com/thing:289712), and [link...

Raspberry Pi 4 Case
thingiverse

**Initial Case Top Design Fix**: The initial top design had rounded edges at the bottom and pointy edges at the top, which caused it not to fit properly with the case base. This was pointed out by Benjamin Summerfield. A new version was created to...

Raspberry Pi Case
thingiverse

... are welcome. 4x M2 x 4mm self-tapping screws to mount the optical sensor (untested) 4x M2.5 x 6mm self-tapping screws to mount the main PCB (untested) 4x M3 x 30mm + locknuts to close the case, making it tamper-resistant with a Torx screw.

Raspberry Pi ZeroW case
thingiverse

Since I need a case that allows my drone to lift without exposing wide open ports, I decided to close off the HDMI and one USB port. In hindsight, I would add another 0.5 mm to the hinge side to create an even smaller gap between the pieces. I was...

G3 Raspberry Pi Case
cults3d

This rpi case is modelled after a retro gaming console, the name of which is lost to the ages, sourced from old polaroids that andrews mom took when we were kids. Features a USB3.0 hub where the controller i/o would have been, as well as a slot for...

Raspberry Pi Relay Case
thingiverse

This is a case to hold a 4 channel relay board. You can either print the 'tight' lid which is held on by friction, or the 'magnet' lid. For the magnets: You'll need 2 8mmX3mm hobby magnets. Glue one in the base and one in the lid. Of course, make...