redcat sixty four 3d models
46731 3d models found related to redcat sixty four.thingiverse
Designed a servo mount for the Redcat Racing Sixty Four Impala R/C lowrider. I picked up a Power HD R-12 servo and had to create a mount to fit it properly. It uses the existing screws from the original servo and fits the chassis quite well. ...
thingiverse
It has become apparent to us that some people would like for the front wheels on the Sixty Four to not toe-in when the front wheels are in full droop, like when hopping. This also allows steering while the front end is in any position. These new...
prusaprinters
I wanted to setup a nice show display for my redcat sixty four so I made these wheel stands. This is also very good to prevent flat spots on the rear wheels since the weight plates put a lot of pressure on them. There are two versions one for the...
thingiverse
I wanted to setup a nice show display for my redcat sixty four so I made these wheel stands. This is also very good to prevent flat spots on the rear wheels since the weight plates put a lot of pressure on them. There are two versions one for the...
cults3d
I wanted to setup a nice show display for my redcat sixty four so I made these wheel stands. This is also very good to prevent flat spots on the rear wheels since the weight plates put a lot of pressure on them. There are two versions one for the...
thingiverse
Customized version of https://www.thingiverse.com/thing:714444 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=714444
thingiverse
I used reconfigured Redcat Everest top links for now, with some extra ends from the lowers. I plan to replace these, however, with the longer original lower links (bent to suit) so that I can move the mounting point closer to the axle. The lowers...
thingiverse
Center mounted servo bracket for Redcat Gen8 Scout. I was too cheap to go with an aluminum one, so I worked this one up myself. Included are standard bumper height and raised bumper height models, pick your flavor! During installation, screws...
thingiverse
Customized version of https://www.thingiverse.com/thing:3045130 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3045130
thingiverse
A simple floor pan for the back of a Redcat Gen8 rc truck. I just wanted something to block light from shining through the truck to make it look more solid and scale appropriate. It is sized to have the rear bumper moved forward a couple of holes to...
thingiverse
Taller body posts for a wide range of redcat/HSP/exceed RC vehicles. ...Made for a exceed RC driftstar (same as HSP flying fish and redcat lightning)
thingiverse
Custom grille for the Redcat Kaiju RC Body. ...Holes for 5mm lights.
thingiverse
Hood louvers to cover the pre drilled holes in the Redcat Kaiju body.
cults3d
Hood louvers to cover the pre drilled holes in the Redcat Kaiju body.
thingiverse
Remix on the 4 link mount published by Redcat. ...I added a stro