sa80 charging handle 3d models
119379 3d models found related to sa80 charging handle.thingiverse
This is a quick piece I knocked up to replace the cocking handle on an Army Armaments L85 airsoft rifle. It's not designed to be an accurate replica of the original, as I'm bastardising this rifle to look a bit steampunk'ish, though it does fit...
thingiverse
Same as the original charging handle, just a little longer.
thingiverse
my kids broke the charging handle on their Xshot 06 gun , so rather than throwing it away ,i just designed a new charging handle.
thingiverse
Glock charging handle slide plate for MCK. ...Uses a 1/4-20 threaded hole to attach a handle.
grabcad
Built based on Madplanet's "G39/G36 charging handle" (https://www.thingiverse.com/thing:3752448)
thingiverse
Charging handle latch for AR15, M4 or M16 modeled to look like the latch in MW3
grabcad
This is the stock charging handle for the Stribog.Has not been printed yet
thingiverse
CAA MCK (gen 2) charging handle to fit Brownells RMR cut slide for Glock (17/19)
thingiverse
FAL inspired charging handle for bear creek arsenal side charging upper receivers that mounts with factory hardware with no modification needed
thingiverse
Charging handle recreation for the Airsoft GHK G5. ... Looking to improve tolerances in the future. Original charging handle breaks pretty easily so this is intended to be a quick replacement part.
thingiverse
The blaster is extremely easy to disassemble and this part will replace the entire charging handle. Just remove all the screws to get to the plunger/charging handle. This is a direct replacement no mods required. ... I've seen a few different...
cults3d
Simple charging handle for Action Army AAP-01. All that is needed is a small M5 bolt. ...No support required
thingiverse
Ambidextrous raptor style charging handle for the Hera glock carbine kit. wrap electrical tape for a tight press fit. ... enjoy
thingiverse
Simple charging handle for Action Army AAP-01. All that is needed is a small M5 bolt. ...No support required