samsung remote print 3d models
1262398 3d models found related to samsung remote print.thingiverse
Remote holder for my Samsung TV that I use as a monitor. ...It laying flat was wasting space.
thingiverse
a remote stand for a samsung remote. If you found this useful, please donate what you think it is worth to my paypal.me. Help cover the time of design. Thanks, Enjoy! ...
thingiverse
... key pad, batteries, battery springs fit in perfectly. You can figure out how best to orient to print. I put battery side down to make the least amount of support material to remove. Battery cover goes tab side up. ...Face goes outside face down.
thingiverse
Easy remote stand for Samsung Smart TV remote control. Check the version of the remote before printing. Samsung is changing those pretty often... ...
prusaprinters
A small stand for the Samsung TV remote as on the picture Category: 3D Printing
thingiverse
A sleeve for your Samsung tv remote. Keeps it from sliding on slick surfaces. ...Makes it somewhat easier to see if you print in hi-vis.
thingiverse
I made this simple modern Samsung remote holder because i couldn't find any quick prints for it.. Printed with 0% infill, the print is skinny. ...I was able to print it in 45 minutes.
thingiverse
Wall mounted holder for samsung remote control. Is mounted using two small screws. ...
thingiverse
This is a Replacement Batteriecover for Samsung Smart Remote AA56-00786A
thingiverse
STAND FOR REMOTE CONTROL SAMSUNG VISIT MY PAGE: https://cults3d.com/en/users/Gianky3D/creations
prusaprinters
This is a simple holder for my Samsung tv remote.The TV model is UE50AU7105K, picture of the remote are included.It is made to use double sided tape.Printed in Orange Prusa PETG, 0.2mm layer at 20% infill with trim.
thingiverse
Simple bed mount for Samsung TV remote. ... Bedframe has a width of 4.5 cm For a FireTV remote mount see: https://www.thingiverse.com/thing:4080605
cults3d
Simple bed mount for Samsung TV remote. ... Bedframe has a width of 4.5 cm For a FireTV remote mount see: https://www.thingiverse.com/thing:4080605
thingiverse
I was just tired of looking for a remote control, I made a quick simple model of a holder for Samsung remotes.
thingiverse
This gives you somewhere to store your samsung remote control on a vertical surface when not in use. ...It does no block the usb-c charger (as found on fancier samsung TV remotes) and fits very well.
thingiverse
This is a simple airtag holder that slides over the bottom of the Samsung Smart Control remote. It fits snugly due to a .25mm tolerance. ... I was able to print this with supports only on the bottom of the airtag rim.