sandevices 3d models

SanDevices E6804 SACN/E1.31 RGB Pixel Controller base. Printed in ABS, but PLA is fine as well. ... I have slightly modified the opening for the power cables since the print was done, allowing more room on the left and top.

Mounting Hardware: 2x - M4 - 8mm bolts (secure mount to PSU) 8x - M3 - 12mm bolts/nuts (secure controller to mount) Links: e6804 - https://sandevices.com/product/e6804-kit/ MW LRS 350 -...

Mounting Hardware: 2x - M4 - 8mm bolts (secure mount to PSU) 8x - M3 - 12mm bolts/nuts (secure controller to mount) Links: e682 - https://sandevices.com/product/e682-kit/ MW LRS 350 -...

Sandevice E682 mounts for the CG1500. Print 2 and use #6 1/2" and #6 3/4" sheet metal screws. Use the 3/4" screws for the top holes and screw through the Controller and mount, into the case standoffs. ...Use 1/2" screws for all the other holes.

Sandevice E682 mounts for the CG1500. Print 2 and use #6 1/2" and #6 3/4" sheet metal screws. Use the 3/4" screws for the top holes and screw through the Controller and mount, into the case standoffs. ...Use 1/2" screws for all the other holes.

Sandevice E682 mounts for the CG1500. Print 2 and use #6 1/2" and #6 3/4" sheet metal screws. Use the 3/4" screws for the top holes and screw through the Controller and mount, into the case standoffs. ...Use 1/2" screws for all the other holes.</p> ...

Sandevice E6804 CG-1500 Mounting Plate. Use #6 1/2" or 3/4" sheet metal screws. ...Designed to have hole spacing for anywhere in the CG1500.

Sandevice E6804 CG-1500 Mounting Plate. Use #6 1/2" or 3/4" sheet metal screws. ...Designed to have hole spacing for anywhere in the CG1500.

Sandevice E6804 CG-1500 Mounting Plate. Use #6 1/2" or 3/4" sheet metal screws. ...Designed to have hole spacing for anywhere in the CG1500.</p> Category: DIY

A case for the SanDevices E692 controller. Anything you think should be changed or added, let me know. I HAVE NOT PRINTED THIS YET! CHECK MY MEASUREMENTS! ... I will remove this warning once I get a chance to print the case!