sangoma s500 3d models
183 3d models found related to sangoma s500.thingiverse
WallBracket for Sangoma S500 and S505 VoiP handset Sets the phone at an angle similar to the desk brackets and allows Network cable and power to be connected if needed
thingiverse
The rails on the S500 are 58-60mm between centers and the rails are about 10mm. The small gap allows a little bit of give when fitting. Print Settings Printer Brand: RepRap ...
thingiverse
Quadcopter S500 Propeller Protection Protection d'hélice Quadri S500
thingiverse
Quadcopter S500 cardan support Support nacelle Quadri S500
thingiverse
Platform holder for kelant s400/s500. print flat on its back. ...no supports needed
thingiverse
GPS Mount for S500 quadcopter Printed with PLA (25% infill) support required
thingiverse
ts832 mount for s500 frame. ...Its a remix from two thing here on thingiverse
thingiverse
S500 quadcopter frame spare landing leg 149mm from top to bottom. ... https://www.youtube.com/watch?v=R7BVC19NltQ
thingiverse
A remix of the excellent cover by simon4web for the CUBOT S500 smart phone. This was my third attempt. ... A snug fitting hard case in ABS.
thingiverse
Gives you an extra bit of space between the top and bottom plate of an S500. ... Printed 4 off in ABS 100% infill.
thingiverse
A cover plate for the S500 Quadcopter frame. I bought mine from Hobbyking, and I have the version with integrated PCB. ...Note that I replaced the legs.
thingiverse
A method to mount the X8R/X6R antenna to your S500 rails. ...Printed at 0.2mm layer 30% infill in ABS.