shaft coupling 3d models
85426 3d models found related to shaft coupling.grabcad
I modelled a simple shaft coupling and then just rendered few of them together just for fun and to test the behavior of shadows and reflections with several colors and materials.
grabcad
19 mm shaft coupling, 76 mm long, suit 6 mm key.Supply your own M5 x 16 mm cap screws.
grabcad
Please leave a like! ... Shaft coupling used for mechanisms with an output of torque in excess of 20K Nm Please leave a like!
cults3d
Shaft coupling for RC boat. Hole for shaft set tiny as possible. In customizer select bolt (M1.6, M2, M2.5, M3, M4, M5). ...Holes are adjusted for them.
thingiverse
Shaft coupling for RC boat. Hole for shaft set tiny as possible. In customizer select bolt (M1.6, M2, M2.5, M3, M4, M5). Holes are adjusted for them. ...
grabcad
This is a Shaft Coupling Unit created with SolidWorks 2015 ... One side for 0.750" to the other side Shaft of 1.000" ... Also the inner 'Yellow' Spider Unit to connect the two coupler sides ... ...Using it on a project so I put the part number on the...
thingiverse
... and overall dimensions. This will make a strong shaft coupling without using much plastic. The code also makes a cleaner stl then my previous coupling. Instructions Open the scad file and generate the custom coupling. ...Parameters are commented.
thingiverse
`This piece holds a flexible shaft coupling, such as those frequently used in 3D printers. It allows to drill into it without the coupling wobbling. I needed this for the Bubblegum CNC kit, as the conversion requires 5mm to 4.5mm coupler, which...
thingiverse
Customized version of http://www.thingiverse.com/thing:15633 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=15633 Instructions Using the following options: washer =...
thingiverse
Customized version of http://www.thingiverse.com/thing:80539 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=80539 Instructions Using the following options: male_diam...
thingiverse
Customized version of https://www.thingiverse.com/thing:15633 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=15633
thingiverse
Customized version of http://www.thingiverse.com/thing:15633 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=15633 Instructions Using the following options: trap = 2...
thingiverse
Fully parametrix flexible shaft coupling made in freecad, inspired by https://www.thingiverse.com/thing:67863.
thingiverse
The shaft couplings crash into my X axis hardware on my Emaker Huxley; these are an attempt to allow full travel. They are smaller OD than the stock ones. After installing them, I don't think they actually give you any more travel; Oh, well. ... ...