shelf riser 3d models
42089 3d models found related to shelf riser.
thingiverse
Customized version of https://www.thingiverse.com/thing:4217583 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4217583
thingiverse
The Desk Riser was designed to be printed by a CR 10 and so I couldn't print it with my Ender 3 V2 because the build plate is smaller. So I decided to cut it in half and put in these connectors. Remixed using TinkerCAD. ... This is the first remix...
cults3d
The Desk Riser was designed to be printed by a CR 10 and so I couldn't print it with my Ender 3 V2 because the build plate is smaller. So I decided to cut it in half and put in these connectors. Remixed using TinkerCAD. ... This is the first remix I've...
thingiverse
Modified Jerooney's model to work with a standard 11-3/4" x 5/8" (299mm x 16mm) shelf board from the hardware store. Also added a peg leg in the center as I cut my board to 45" and I did not want to see any future sagging. ... The end pieces are...
thingiverse
Simple shelf or riser if you need extra cooling underneath or simple need to mount something else on to of your VTX.
thingiverse
Customized version of https://www.thingiverse.com/thing:4217583 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4217583
thingiverse
Uses the BURHULT Shelf from Ikea - white59x20 cm I've uploaded the original as seen in the photo - but the tolerances are very tight to prevent racking (I learnt the term just now from kap_bid on Reddit). ... Rather than throwing out a modified but...
thingiverse
Customized version of https://www.thingiverse.com/thing:511489 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=511489
prusaprinters
The monitor riser I was given at my workplace was a bit too high for my monitor, so I decided to get the cheapest Ikea Burhult shelf (the cheapest I found) and make some adapters that insert into the shelf by pressure, no screws needed. I wanted...
prusaprinters
The internal dimensions for the wooden shelf are:Width - 198.8mm and Height - 23.8mmPrint Settings :Filament tested : PLA, PETGlayer height: 0.28mmInfill: 20%Perimeters: 4Supports: NoBrim: NoI hope u will enjoy it.
prusaprinters
// PLEASE PRINT WITH 0.2 QUALITY OR FINER. ...//(I printed mine out at 0.2 quality, no supports or rafts).This is the first remix I've ever done I am not very experienced with remixing and other types of things relating but I decided to give it a...
thingiverse
The riser lifts the shelf up by 3 1/2 inches. The slot takes in a piece of metal that measures .587"W x 58"L x 0.080" H for a super tight fit. No need to use glue or hardware at all. Not recommended for heavy loads, though. ...Here is the link to the...
thingiverse
NEW & IMPROVED Anchorable Shelf Leg - (efficient, faster, and improved) ["CLICK HERE!"](https://www.thingiverse.com/thing:4807915) Simple, low-poly LEG for a shelf/riser/inkjet printer or monitor stand/table. Measures 7" tall. Use any scrap 3/4"...