shower door shims 3d models

87764 3d models found related to shower door shims.

Glass Shower door hinge shim / spacer
thingiverse

It turns out that my shower door needed to be a bit further from the wall because of the tub. SO I designed a spacer. The hinge holes are 35mm apart and 70mm apart. ...50% infill - 0.15 layer height

Shower Rod Riser Shims
thingiverse

Risers to support the ends of twist-tighten shower rods and prevent the curtain from hanging so low. My shower rod is one of those twist-to-tighten ones that stays up by compression and friction. It recently fell down (and tore a chunk out of the...

Door Hinge Shims
thingiverse

You can find shim sizes of the following thicknesses. This allows you to customize the shim needed to correct your alignment. 1/32" (0.79mm) 1/16" (1.59mm) 3/32" (2.38mm) 1/8" (3.16mm) 5/32" (3.97mm) 3/16" (4.76mm) 1/4" (6.35mm) You...

Cabinet door hinge shims
thingiverse

Rather than bending the hinges, cutting pockets in the doors or frames, or using cardboard or toothpicks, which are the "standard" fixes to re-align doors like this, I chose instead to shim the hinges. It is quick and easy to do, and works like a...

Door knob insert shims
thingiverse

Print Settings Rafts: Doesn't Matter Supports: Yes Infill: 15% Notes: For my knobs, these shims are a tight fit and get crushed when the door knob screws are tightened. Your door thickness/knob screw locations may differ, so I've included the scad...

door hinge shims
thingiverse

This is a door hinge shim for residential doors. These go between the metal hinge and wood frame or door to help center and level a door. There are 4 thicknesses (from 0.2 mm to 2.0 mm) included. This is version 4 or so of printing and getting the...

Door Hinge Shims 1-3mm
thingiverse

Remix of jsjamboree's 3.5" Door Hinge Shim. I just added the 2mm and 3mm size to have a variety depending on the situation. Also labelled them to know the thickness at a quick glance. ... I was able to print 8 at a time on my Ender 3 S1, but looking...

Water-saving shims for shower head
prusaprinters

Energy prices are skyrocketing, winter is coming, and unfortunately I'm heating my water with electricity, so I've designed this shim to reduce my energy bill.I'm using the 3.5 mm version and was able to reduce my water flow from 12 l/min to 8...